User Manual
Table Of Contents
- ASSEMBLY INSTRUCTIONS
- H3X SERIES PARTS DIAGRAM
- H4X SERIES PARTS DIAGRAM
- GRILL HEAD HARDWARE PACK - B102153
- UNPACK AND REMOVE LID
- INSERT BURNER HOLD-DOWN BOLT
- WIND DEFLECTOR PLACEMENT
- INSERT CONTROL PANEL
- ATTACH IGNITOR WIRE
- INSTALL BURNER ASSEMBLY
- CONNECT IGNITOR LEADS
- KNOB AND BATTERY PLACEMENT
- INSTALL HANDLE
- REINSTALL LID
- INSTALL RACKS
- INSTALL WARMING RACK
- PROPANE GAS GRILLS
- CONNECTING PROPANE GAS GRILL
- CONNECTING NATURAL GAS GRILL
- NATURAL GAS GRILLS
- COMPLETED ASSEMBLY
- OWNER’S MANUAL FOR H3X AND H4X GRILLS
- H3X SERIES PARTS DIAGRAM
B102231-3-0615Page 14
1
2
3
4
Slide the Venturi onto the Valve
Assembly as shown.
Raise the end of the Burner Bracket
and slip it over the Phillips Truss Head
Screw. The screw will fit into the hole
on the Burner Bracket.
Insert Cotter Pin.
Note: Ignitor Wires run through center
hole with Venturi.
Insert the Burner Assembly into
the Grill bottom with the Venturi
Tubes facing the front of the Grill.
INSTALL BURNER ASSEMBLY
COTTER PIN,
B057805(1)