Installation Guide

IMPORTANT

Please be advised that the provided cold water T-valve should be

installed at the ﬁll valve under the toilet tank, and NOT at the cold

water supply coming from the wall.

Check Water Supply Line

Check the water supply line that connects the toilet

tank ﬁll valve to the water shuto valve at the wall.

If it is a rigid pipe, you will need to purchase a ﬂexible water

supply hose to replace it before installing the FreshSpa Comfort+.

The length of the hose may vary and the top connection size

should be ⁄" ballcock to connect to the T-valve that you will install

under the toilet tank and the bottom connection will vary (most

common are ⁄" and ½” female compression).

Before Installation

PRODUCT INSTALLATION

PAGE 1
PRODUCT INSTALLATION Before Installation IMPORTANT Please be advised that the provided cold water T-valve should be installed at the fill valve under the toilet tank, and NOT at the cold water supply coming from the wall. Check Water Supply Line Check the water supply line that connects the toilet tank fill valve to the water shutoff valve at the wall. If it is a rigid pipe, you will need to purchase a flexible water supply hose to replace it before installing the FreshSpa Comfort+.
PAGE 2
PRODUCT INSTALLATION Installation Please read these instructions carefully before installing your FreshSpa Comfort+. Failure to do so could result in flooding, leaking or damage to the product. 1. Existing Toilet Seat Removal a. Lift hinge covers and use flathead or Phillips head screwdriver to remove the mounting bolts. Alternatively, you may need to loosen mounting bolts underneath the seat. b. Remove the toilet seat and set the seat, mounting bolts and hardware aside. Step 1b 2.
PAGE 3
PRODUCT INSTALLATION Installation Installing the Bidet Attachment 1. Install Adjustable Mounting Brackets into the Bidet Attachment. Place circular mounting brackets into the circular openings of the bidet attachment. 2. Install Bidet Attachment on Toilet a. Place bidet attachment on the toilet so the nozzle is as close to the back of the toilet bowl as it will go. This will vary by toilet. b. Make sure the adjustable brackets line up with the holes in the toilet fixture.