Instructions / Assembly

ManualsBrandsBrondell ManualsBathFreshSpa Comfort+ Ambient Temperature Non-Electric Bidet Attachment in White

Product Parts

PRODUCT INFORMATION

1. Bidet Attachment

2. Adjustable Mounting Brackets

3. Cold Water T-Valve Connector

(⁄" x ⁄" x ⁄")

4. Cold Water Braided Metal Hose

5. Large Rubber Washers (2)

6. Teﬂon Tape

Summary of content (5 pages)

PAGE 1
PRODUCT INFORMATION Product Parts 1. Bidet Attachment 2. Adjustable Mounting Brackets 3. Cold Water T-Valve Connector (7/8" x 7/8" x 3/8") 4. Cold Water Braided Metal Hose 5. Large Rubber Washers (2) 6.
PAGE 2
PRODUCT INSTALLATION Before Installation IMPORTANT Please be advised that the provided cold water T-valve should be installed at the fill valve under the toilet tank, and NOT at the cold water supply coming from the wall. Check Water Supply Line Check the water supply line that connects the toilet tank fill valve to the water shutoff valve at the wall. If it is a rigid pipe, you will need to purchase a flexible water supply hose to replace it before installing the FreshSpa Comfort+.
PAGE 3
PRODUCT INSTALLATION Installation Please read these instructions carefully before installing your FreshSpa Comfort+. Failure to do so could result in flooding, leaking or damage to the product. 1. Existing Toilet Seat Removal a. Lift hinge covers and use flathead or Phillips head screwdriver to remove the mounting bolts. Alternatively, you may need to loosen mounting bolts underneath the seat. b. Remove the toilet seat and set the seat, mounting bolts and hardware aside. Step 1b 2.
PAGE 4
PRODUCT INSTALLATION Installation Installing the Bidet Attachment 1. Install Adjustable Mounting Brackets into the Bidet Attachment. Place circular mounting brackets into the circular openings of the bidet attachment. 2. Install Bidet Attachment on Toilet a. Place bidet attachment on the toilet so the nozzle is as close to the back of the toilet bowl as it will go. This will vary by toilet. b. Make sure the adjustable brackets line up with the holes in the toilet fixture.
PAGE 5
PRODUCT OPERATION Using the FreshSpa Comfort+ To engage the front wash setting, turn the dial counterclockwise towards the “FRONT” wash zone. • The further the dial is turned, the higher the water pressure will be. • To lower the water pressure, turn the nozzle back towards the center. To engage the rear wash setting, turn the dial clockwise toward the “REAR” wash zone. • The further the dial is turned, the higher the water pressure will be.