Owner's Manual & Installation Guide

SWASH INSTALLATION (cont.)

NOTES:

• Make sure to only use a grounded GFCI (ground fault circuit interrupter) electrical outlet. In

the case of a short circuit, a grounded GFCI outlet may help prevent electric shock or injury.

• If it is necessary to use an extension cord, only use those rated for a minimum of 15 amps

with a three-wire extension cord with a three-blade grounding plug.

12. Press the “REAR WASH” button on the control arm to ﬁll the water tank. The bidet will beep

continuously while it ﬁlls and then issue one long beep when the water tank is full. Wait 3-5

minutes for the water to heat, and then the Swash will be ready to use.

13. Follow instructions on Page 16 for using the Swash.

EXTERNAL BIDET FILTER INSTALLATION

1. Turn O Water Supply Valve and Flush Toilet.

a. Turn water valve o to stop the ﬂow of water.

b. Flush toilet and hold down handle to completely empty tank.

2. Disconnect the Bidet Hose from the T-Valve

3. Connect the female end of the Swash Filter to the open T-Valve connection.

4. Connect the Bidet Hose to the male end of the Swash Filter.

5. Turn the toilet water supply valve back on.

Step 2

FLOW

Step 3

FLOW

Step 4

NOTE:

• Customers with hard water, well water, and softened water can extend the life of their bidet

seat by purchasing and installing an external inline water ﬁlter to be used with the Swash.

The bidet ﬁlter should be changed every six months, and can be purchased online at

brondell.com.