Owner's Manual & Installation Guide

16
OPERATING THE SWASH cont.
USING THE SWASH SE400
Warm Water Wash
When ready to wash, press the “Rear Wash” or “Front Wash” button on the control panel one time
to initiate a wash. The nozzle will self-clean, extend into the toilet bowl, spray for two minutes,
turn o automatically, retract, and self-clean once again.
1. Pressing the “Rear” or “Front” button a second time while the wash is running will cause the
nozzle to oscillate forward and backward, providing a wider range of wash spray. Press again
to cancel the move function.
2. While washing, users can adjust the water temperature, pressure, and nozzle position settings,
as well as initiate the massage feature by following the notes on Page 15.
3. If you would like to stop the wash before the two minute cycle ends, press the “Stop” button to
discontinue water flow.
4. After extended use the water may decrease in temperature if a LO, MEDIUM, or HI water
temperature setting is selected. To regain warmer water, stop all wash functions for three
minutes to allow the bidet to reheat the water.
Prepare for Wash
Sit on the seat to ensure skin-to-seat contact on the Seat Sensor. Once contact is made the seat
will automatically perform many functions:
1. The seat will give an audible beep letting you know the Seat Sensor has been engaged.
2. The water pressure indicator lights will come on displaying the current setting.
3. If the bidet was set to Eco Mode, the seat and water temperature will rise to the set
temperature settings.
Warm Air Dryer Function
Press the “Dry” button to activate the warm air dryer. The dryer will run for two minutes and turn
o automatically.
1. While the air dryer is operating, users can adjust the dryer temperature to a comfortable level
using the Dry “
+”
and “–” buttons. The dry temperature will be reflected on the five indicator
LEDs.
2. If you would like to stop the dryer before the two minutes has elapsed, press Stop.
NOTES:
• The wash functions will not work unless the sensor in the seat detects someone sitting
down (with the built-in skin conductivity sensor). To override the Seat Sensor, please see
the instructions on Page 18.