Owner's Manual & Installation Guide

OPERATING THE SWASH cont.

SPECIAL MODE OPERATIONS

Seat Sensor Override

The Seat Sensor is activated at the factory by default. Completing the following steps will bypass

the body sensor located in the seat and allows the wash functions and dry functions to operate

without the sensor being engaged. Use caution in this mode.

1. Unplug the Swash bidet seat.

2. Press the two Water Pressure/Dry Temp buttons (+ and –) and plug the seat in while holding

the two buttons down.

3. Keep holding the two Water Pressure/Dry Temp buttons (+ and –) down for ﬁve seconds.

A beep will sound, indicating that the Seat Sensor has been overridden. To test that the

procedure worked, press the Dry button. If the Warm Air Dryer comes on without anyone

sitting on the seat, you have successfully overridden the Seat Sensor.

4. You can resume using the seat as normal.

5. To reactivate the Seat Sensor, repeat Steps 1-3.

NOTE:

• Do not sit on the seat when in Special Mode Operations. The process will not work while

the seat is occupied.

Activating/Deactivating Silent Mode

By default, the Swash will beep to conﬁrm commands from the control panel. Follow the steps

below to silence the beeping sounds.

1. Press and hold down the Rear Wash/Move button and the “–” Water Pressure/Dry Temp button

at the same time for four seconds.

2. A beep will sound, indicating that the Silent Mode has been activated.

3. To deactivate Silent Mode, repeat Steps 1-2.