User guide

- 17 -
operating in the Lock-Out mode.
Figure 17
To review data, print data or exit the Lock-Out mode, you have to disable lock-out.
1) Press the PROG RUN key.
2) Press the OPTION key and the Lock-out Options screen will be displayed.
3) Press NUMBER 3 to disable Lock-Out and the screen changes to the step sequence screen
(Figure 14) ready for you to select your step sequence.
4) Press CANCEL and you are returned to the main screen.
Refer to Section IV. The Options Menu, for data review and/or printing.
III.6 Clearing a Speed Set from Memory
If a speed set program is no longer required it may be deleted from memory using the following
procedure. From the main screen:
1) Press the CLEAR SPEED key.
2) Enter the number of the speed set you wish to clear.
3) Press key number 1 = YES to clear the speed set.
4) Press CANCEL to return to the main screen.
Note: You cannot CLEAR a speed set from memory if it is loaded and ready to run (as shown
in Figure 13). You must remove it from the selected use position first. You can unload
(but not delete) the currently loaded program using the following procedure. From the
main screen:
1) Press the PROG SPEED key twice.
III.7 Printing a Speed Set Stored in Memory
Speed set programs stored in any of the 10 speed set memory locations may be printed to the serial
printer. The following procedure is used starting from the main screen:
1) Press the PROG SPEED key.
2) Select the speed set to be printed. (See Figure 9)
3) Press key NUMBER 1 = Review/Modify. (See Figure 11)
4) Press the OPTION key.
5) In response to the screen display, make sure your printer is ready for printing, then press any