Manualshelf

User guide

ManualsBrandsBrookfield ManualsMeasuring instrumentsDV-III Rheometer
11121314151617181920
- 20 -
Figure 20
If the printer is connected correctly, and is “on line”, but does not print, this indicates that the printer
is not using the X-on/X-off protocol and HKS should be set to “OFF”. Press the CANCEL key to
return to the main screen, then:
1) Press the OPTION key to display the Options Menu.
2) Press the NUMBER 6 key to set HSK to OFF.
3) Press the CANCEL key to return to the main screen.
4) Press the NEXT key to print a line of data.
If the printer still does not print, check all printer connections, power switch and funtion modes.
Be sure the printer is on-line ready to receive data.
Test data may be printed in the following manner:
1) After each step in a Next Speed Set mode or Prog Speed Set mode program when the
print option is set to 3 = PRINT NEXT/LINE (PRTN).
2) At the conclusion of a data gathering sequence. Before the data gather takes place, the
DV-III is set to STOP PRINTING (PRTO) mode. Press the OPTION key. Press 1 in the
OPTIONS menu. Press1 to set PRTO. Run the test. The data is automatically stored in
the DV-III.
The Options Menu (3 DATA) is used to print the test data.
3) Printed continuously when the print option is set to 2 = CONTINUOUS PRINT (PRTC).
Data is printed as quickly as possible (approximately one line per second). A sample of
this print mode is shown in Figure 21.
RPM=70.0 MD=2R SPL=31 %=42.3 cP=969 D/CM2=230 1/SEC=23.8 T=22.2C
RPM=70.0 MD=2R SPL=31 %=42.3 cP=969 D/CM2=230 1/SEC=23.8 T=22.2C
RPM=70.0 MD=2R SPL=31 %=42.3 cP=969 D/CM2=230 1/SEC=23.8 T=22.2C
RPM=70.0 MD=2R SPL=31 %=42.4 cP=966 D/CM2=230 1/SEC=23.8 T=22.2C
RPM=70.0 MD=2R SPL=31 %=42.4 cP=966 D/CM2=230 1/SEC=23.8 T=22.2C
RPM=70.0 MD=2R SPL=31 %=42.4 cP=971 D/CM2=231 1/SEC=23.8 T=22.2C
RPM=70.0 MD=2R SPL=31 %=42.4 cP=969 D/CM2=231 1/SEC=23.8 T=22.2C
RPM=70.0 MD=2R SPL=31 %=42.3 cP=969 D/CM2=230 1/SEC=23.8 T=22.2C
Figure 21