Operation Manual
1
English
CAUTION
When leaving this sewing machine unattended, the main power and light switch of the machine must be
switched off or the plug must be removed from the socket-outlet.
When servicing the sewing machine, or when removing covers or changing the light bulb, the machine or
the electrical set must be disconnected from the supply by removing the plug from the socket-outlet.
FOR USERS IN THE UK, EIRE, MALTA AND CYPRUS ONLY.
If your sewing machine is fitted with a 3 pin non rewireable BS plug then please read the following.
IMPORTANT
If the available socket outlet is not suitable for the plug supplied with this equipment, it should be cut off and an
appropriate three pin plug fitted. With alternative plugs an approved fuse must be fitted in the plug.
NOTE
The plug severed from the mains lead must be destroyed as a plug with bared flexible cords is hazardous if engaged in
a live socket outlet. In the event of replacing the plug fuse, use a fuse approved by ASTA to BS 1362, i.e. carrying the
ASA
mark, rating as marked on plug.
Always replace the fuse cover, never use plugs with the fuse cover omitted.
WARNING
DO NOT CONNECT EITHER WIRE TO THE EARTH TERMINAL WHICH IS MARKED WITH THE LETTER
"E", BY THE EARTH SYMBOL
OR COLOURED GREEN OR GREEN AND YELLOW.
The wires in this mains lead are coloured in accordance with the following code:
Blue: Neutral
Brown: Live
As the colours of the wiring in the mains lead of this appliance may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows.
The wire which is coloured blue must be connected to the terminal which is marked with the letter "N" or coloured
black or blue.
The wire which is coloured brown must be connected to the terminal which is marked with the letter "L" or coloured red
or brown.
To give your machine a longer life
1. Do not store this machine in direct sunlight or in high humidity conditions. Do not use or store the machine near a
heater, iron, halogen lamp or other hot object.
2. Use only mild soaps or detergents to clean the case. Benzene, thinner, and scouring powders can damage the
case and machine, and should never be used.
3. Do not drop or hit the machine.
4. Always consult this manual before you replace or fit the presser foot, needle, or any other parts to make sure you fit
them correctly.
To repair or adjust the machine
If the machine breaks down or needs adjustment, first follow the troubleshooting table to inspect and adjust
the machine yourself. If the problem persists, consult your local authorized dealer.
"SAVE THESE INSTRUCTIONS"
"This sewing machine is intended for domestic use only."