Owner's Manual

LK3-B438E Mark II

3-8 . Installing the machine head

1. Insert the head hinges q into the machine head so that they are parallel, and then secure them with the

two set screws w.

2. Place the machine head gently on top of the rubber cushions e and cushions r.

NOTE:

Pull the cords t out as shown in the illustration above in order to prevent them from being clamped by the machine

head.

3. Install the hinge presser y with the two screws u.

3-9 . Installing the head rest

Tap the head rest q into the table hole.

NOTE:

Tap the head rest securely into the table hole.

3-10 .Installing the liquid cooling tank, optional

1. Remove the rubber plug, and then push the liquid

cooling tank q.

2. Tighten it with the set screw w.

3. INSTALLATION