Owner's Manual

LK3-B438E Mark II

DIPB-1

DIPB-2

DIPB-3

DIPB-4

DIPB-5

DIPB-6

DIPB-7

DIPB-8

Motion when set to ON

First two stitches are sewn at a low speed of 260 rpm.

Last two stitches are sewn at a low speed of 260 rpm.

–

Last two stitches are sewn at a low speed of 700 rpm.

First two stitches are sewn at a low speed of 400 rpm.

Low speed sewing is not performed at the start of sewing.

The motor operates in reverse when the upper shaft stops, to return the needle

bar to close to its highest position.

Area checking of the sewing data is not carried out.

Switch

DANGER

12-3 . DIP switches inside the control box

Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from

the wall outlet before opening the face plate of the control box. Touching areas where high volt-

ages are present can result in severe injury.

The DIP switches q inside the control box are used to

change functions which do not often need to be

changed once they have been set.

The functions can be changed as shown in the table

below by changing the positions of the DIP switches

* All DIP switches are set to OFF at the time of ship-

ment.

NOTE:

When opening the cover, hold it securely so that it does

not fall down.

12 . CHANGING FUNCTIONS USING THE DIP SWITCHES