ADVANCED USER’S GUIDE DCP-7055 DCP-7055W DCP-7057 DCP-7057W DCP-7060D DCP-7065DN DCP-7070DW Not all models are available in all countries.
User's Guides and where do I find it? Which manual? What's in it? Where is it? Safety and Legal Read this Guide first. Please read the Safety Instructions before you set up your machine. See this Guide for trademarks and legal limitations. Printed / In the Box Quick Setup Guide Follow the instructions for setting up your machine and installing the drivers and software for the operating system and connection type you are using.
Table of Contents 1 General Setup 1 Memory Storage .................................................................................................... 1 Ecology features .................................................................................................... 1 Toner Save ...................................................................................................... 1 Sleep Mode .....................................................................................................
iii
1 General Setup Memory Storage Your menu settings are stored permanently, and in the event of a power failure will not be lost. Temporary settings (for example, Contrast) will be lost. 1 1 1 Ecology features 1 Toner Save 1 You can save toner using this feature. When you set Toner Save to On, prints appear lighter. The default setting is Off. a b Press Menu. Press a or b to choose 1.General Setup and press OK. c Press a or b to choose 2.Ecology and press OK. d Press a or b to choose 1.
Chapter 1 While the machine is in sleep mode the LCD will show Sleep. Toner Settings a b Toner Setting (Continue Mode) Press Menu. Press a or b to choose 1.General Setup and press OK. c Press a or b to choose 2.Ecology and press OK. d Press a or b to choose 2.Sleep Time and press OK. e Press a or b to select the length of time the machine is idle before entering sleep mode. Press OK. f a b Press Stop/Exit.
General Setup LCD Contrast 1 User Settings Report You can change the contrast to make the LCD look lighter or darker. You can print a list of the settings you have programmed. a b a b c Press Menu. Press a or b to choose 1.General Setup and press OK. Press a or b to choose 3.LCD Contrast and press OK. d Press a to make the LCD darker. Or, press b to make the LCD lighter. Press OK. e Press Stop/Exit. 1 1 Press Menu. (For DCP-7055/DCP-7057/DCP-7060D) Press a or b to choose 3.Machine Info.
Chapter 1 Network Configuration Report (For DCP-7055W / DCP-7057W / DCP-7065DN / DCP-7070DW) You can print a report showing the current network configuration, including the internal print server settings. WLAN Report (For DCP-7055W / DCP-7057W / DCP-7070DW) 1 Prints the result of wireless LAN connectivity diagnosis. a b Note Node name: Node name appears in the Network Configuration List. The default node name is “BRNXXXXXXXXXXXX”. a b (For DCP-7070DW) Press a or b to choose 5.Machine Info.. Press OK.
General Setup Scanning using a scanner driver 1 1 For information about using a scanner driver, see Scanning a document using the TWAIN driver or Scanning a document using the WIA driver in the Software User's Guide.
2 Making copies Copy settings 2 When you want to quickly change the copy settings temporarily for the next copy, use the temporary COPY keys. You can use different combinations. DCP-7055 / DCP-7055W / DCP-7057 / DCP-7057W DCP-7060D / DCP-7065DN / DCP-7070DW 2 2 The machine returns to its default settings one minute after copying. Stop copying To stop copying, press Stop/Exit.
Making copies Using the Options key 2 Make sure you are in Copy mode. Use the Options key to quickly set the following copy settings temporarily for the next copy.
Chapter 2 Press Menu selections Options Enlarge/Reduce 100%* Page 9 97% LTRiA4 94% A4iLTR 91% Full Page 85% LTRiEXE 83% 78% 70% A4iA5 50% Custom(25-400%) Auto 1 200% 141% A5iA4 104% EXEiLTR Page Layout Off(1 in 1)* 2 in 1 (P) 2 2 in 1 (L) 2 2 in 1 (ID) 4 in 1 (P) 2 4 in 1 (L) 2 1 When using the ADF 2 (P) means Portrait and (L) means Landscape. The factory settings are shown in Bold with an asterisk.
Making copies Improving copy quality 2 You can choose from a range of quality settings. The default setting is Auto. Auto Auto is the recommended mode for ordinary printouts. Suitable for documents that contain both text and photographs. Text Suitable for documents containing mainly text. Sorting copies using the ADF (For DCP-7065DN) You can sort multiple copies. Pages will be stacked in the order 1 2 3, 1 2 3, 1 2 3, and so on. a b Load your document in the ADF. c Press Options.
Chapter 2 f Press a or b to enter an enlargement or reduction ratio from 25% to 400%. b Press a or b to choose 2.Copy. Press OK. Press OK. c (For DCP-7065DN) Auto sets the machine to calculate the reduction ratio that best fits the size of paper. Auto is only available when using the ADF. Press a or b to choose 3.Contrast. Press OK. d Press a or b to increase or decrease the contrast. Press OK. Custom(25-400%) allows you to enter a ratio from 25% to 400%. e Press Stop/Exit. Press Start.
Making copies Making N in 1 copies (page layout) You can reduce the amount of paper used when copying by using the N in 1 copy feature. This allows you to copy two or four pages onto one page. If you want to copy both sides of an ID card onto one page, see 2 in 1 ID Copy on page 12. IMPORTANT • Please make sure the paper size is set to Letter or A4. g Put the next page on the scanner glass. Press OK. Repeat steps f and g for each page of the layout.
Chapter 2 2 in 1 (L) 4 in 1 (P) b Press Options. Press a or b to choose Page Layout. Press OK. c Press a or b to choose 2 in 1 (ID). Press OK. d Press Start. After the machine scans the first side of the card, the LCD will show the following instruction. Turn over the ID Then Press Start 4 in 1 (L) 2 in 1 ID Copy You can copy both sides of your identification card onto one page, keeping the original card size.
Making copies Duplex Copying (1-sided to 2-sided) (For DCP-7060D / DCP-7065DN / DCP-7070DW) Duplex Copy (long edge flip) f Place the next page on the scanner glass. Press OK. Repeat steps e and f for the remaining pages. g After all the pages have been scanned, press b in step e to finish. 2 2 1 sided i 2 sided L Portrait 1 1 2 2 Landscape 11 1 a b 2 2 Load your document. Press a or b to enter the number of copies you want. c Press Duplex and a or b to select 1sidedi2sided L. Press OK.
Chapter 2 Advanced Duplex Copy (short edge flip) 1 sided i 2 sided S Portrait 1 1 2 2 Landscape 11 1 2 2 a b Load your document. c Press Duplex and a or b to select 1sidedi2sided S. Press OK. d Press Start to copy the page. (For DCP-7065DN) If you placed the document in the ADF, the machine scans the pages and starts printing. If you are using the scanner glass, go to step e. e After the machine scans the page, press a to scan the next page.
A Routine maintenance Cleaning the machine Clean the outside and inside of the machine regularly with a dry, lint-free soft cloth. When you replace the toner cartridge or the drum unit, make sure that you clean the inside of the machine. For details about cleaning the machine, see the Basic User's Guide. WARNING DO NOT use cleaning materials that contain ammonia, alcohol, any type of spray, or any type of flammable substance to clean the outside or inside of the machine.
Checking the remaining life of the drum unit A Packing and shipping the machine You can see the machine’s parts life on the LCD. a b Press Menu. Press a or b to choose one of the following: 3.Machine Info. (DCP-7055/DCP-7057/DCP-7060D) 4.Machine Info. (DCP-7055W/DCP-7057W/ DCP-7065DN) 5.Machine Info. (DCP-7070DW) Press OK.
Routine maintenance d Put the protective material (1) in the machine with the “REMOVE” text to the left, as shown in the illustration. i Pack the AC cord and printed materials in the original carton as shown below: A FRONT (1) e Put the drum unit and toner cartridge assembly back into the machine. f Put the elastic band over the handle of the drum unit, as shown in the illustration. j g h Close the carton and tape it shut. Close the front cover.
B Glossary B This is a comprehensive list of features and terms that appear in Brother manuals. Availability of these features depends on the model you purchased. ADF (automatic document feeder (For DCP-7065DN)) The document can be placed in the ADF and scanned one page at a time automatically. Cancel Job Cancels a programmed print job and clears the machine’s memory. Contrast Setting to compensate for dark or light documents, by making copies of dark documents lighter and light documents darker.
C Index C P Copy 2 in 1 ID Copy .......................................12 brightness .............................................10 Contrast ................................................10 Enlarge/Reduce ......................................9 keys ........................................................6 N in 1 (page layout) ..............................11 Options key .............................................7 quality .....................................................9 sort (ADF only) .....
These machines are approved for use in the country of purchase only. Local Brother companies or their dealers will only support machines purchased in their own countries.