Operation Manual

Chapter 5
48
Restoring all fax settings to
the factory settings 5
You can restore all the fax settings you have
changed to the factory settings. These
settings will stay until you change them again.
a Press (Fax).
b Press d or c to display
Factory Reset.
c Press Factory Reset.
d Press Yes.
e Press Stop/Exit.
Sending a fax manually 5
Manual transmission lets you hear the
dialling, ringing and fax-receiving tones while
sending a fax.
Note
To send a multiple page fax, use the ADF.
a Press (Fax).
b Load your document.
c To listen for a dial tone pick up the
handset of an external telephone.
d Dial the fax number using the dial pad.
You can also enter the fax number on
the LCD by pressing Phone Book and
Send a fax, or you can press a
One Touch key on the machine’s control
panel.
Note
If your network supports the LDAP
protocol you can search for fax numbers
and E-mail addresses on your server.
(See LDAP operation in the Network
User’s Guide on the CD-ROM.)
e When you hear the fax tone, press
Mono Start or Colour Start.
Then press Send on the LCD.
f Replace the handset.
Out of Memory message 5
If you get an Out of Memory message
while scanning the first page of a fax, press
Stop/Exit to cancel the fax.
If you get an Out of Memory message
while scanning a subsequent page, you will
have the option to press Mono Start or
Colour Start to send the pages scanned so
far, or to press Stop/Exit to cancel the
operation.
Note
To free up extra memory, turn off Memory
Receive or print the faxes that are in the
memory. (See Memory Receive
(Monochrome only) on page 54 or
Printing a fax from the memory
on page 54.)