User Manual
Table Of Contents
- SOFTWARE USER’S GUIDE
- Table of Contents
- Windows®
- Printing
- Scanning
- ControlCenter3
- Remote Setup (Not available for DCP models, MFC-253CW, MFC-255CW, MFC-257CW and MFC-295CN)
- Brother PC-FAX Software (MFC models only)
- PhotoCapture Center™
- Firewall settings (For Network users)
- Apple Macintosh
- Printing and Faxing
- Scanning
- ControlCenter2
- Remote Setup & PhotoCapture Center™
- Using the Scan key
- Index
- brother CHN-ENG
Firewall settings (For Network users)
110
7
h Add port 137 for both network scanning and Network PC-Fax receiving by entering the information
below:
1In Description of service: Enter any description, for example “Brother Network Print”.
2In
Name or IP address (for example 192.168.0.12) of the computer hosting this service on your
network: Enter “Localhost”.
3In External Port number for this service: Enter “137”.
4In Internal Port number for this service: Enter “137”.
5 Make sure UDP is selected.
6Click OK.
i Make sure that the new setting is added and is checked, and then click OK.
Windows Vista
®
users 7
a Click the button, Control Panel, Network and Internet, Windows Firewall and click
Change settings.
b When the User Account Control screen appears, do the following:
Users who have administrator rights: Click Continue.
For users who do not have administrator rights: Enter the administrator password and click OK.
c Make sure that Windows Firewall on the General tab is set to On.