User Manual

USB cable scanning
167
12
Guidelines for Auto Crop 12
 This setting is only available for paper that is rectangular or square.
 If your document is too long or wide, this setting does not work properly.
 You must place the documents away from the edges of the scanner glass as shown in the illustration.
 You must place the documents at least 10 mm apart from each other.
 Auto Crop adjusts the skew of the document on the scanner glass, but if your document is skewed more
than 10 degrees, this setting will not work.
 The ADF must be empty to use the Auto Crop.
 The Auto Crop feature is available for up to a maximum of 16 documents depending on size of your
documents.
a Put a memory card or USB Flash memory drive into your machine.
Note
• DCP-373CW, DCP-375CW, DCP-377CW, MFC-253CW, MFC-255CW and MFC-257CW do not support
using a USB Flash memory drive.
• DCP-193C, DCP-195C, DCP-197C, DCP-373CW, DCP-375CW, DCP-357CW, MFC-253CW,
MFC-255CW, MFC-257CW and MFC-295CN do not support using a CompactFlash
®
.
CAUTION
DO NOT take out the memory card or USB Flash memory drive while Photo Capture is blinking to avoid
damaging the card, USB Flash memory drive or data stored on the card.
If you take out the memory card or USB Flash memory drive while the Photo Capture key is flashing, you
must restart your computer at once before putting the same memory card or USB Flash memory drive into
the machine. If you do not restart your computer, the data on your media may be destroyed.
b Load your document.
c Press (Scan).
d Press a or b to choose Scan to Media.
Press OK.
Do one of the following:
 If you want to change the quality, go to step e.
 Press Mono Start or Colour Start to start scanning without changing additional settings. Go to
step h.