User Manual
Table Of Contents
- Quick Setup Guide MFC-8510DN/MFC-8520DN
- Start Here
- 1 Unpack the machine and check the components
- 2 Remove the packing material from the machine
- 3 Load paper in the paper tray
- 4 Connect the power cord and telephone line
- 5 Set your country (for Australia/New Zealand customer only)
- 6 Choose a Receive Mode
- 7 Set the LCD contrast (if needed)
- 8 Set the date and time
- 9 Enter personal information (Station ID)
- 10 Fax Transmission Report
- 11 Set tone or pulse dialling mode (not available in New Zealand)
- 12 Set the telephone line compatibility
- 13 Dial Prefix
- 14 Set Daylight Saving Time
- 15 Set the Time Zone
- 16 Choose your connection type
- For USB Interface Users (Windows® XP/XP Professional x64 Edition/Windows Vista®/Windows® 7)
- For USB Interface Users (Mac OS X 10.5.8 - 10.7.x)
- For Wired Network Interface Users (Windows® XP/XP Professional x64 Edition/Windows Vista®/Windows® 7)
- For Wired Network Interface Users (Mac OS X 10.5.8 - 10.7.x)
- For Network Users
- Other Information
- Options and Consumables
- Start Here
4
3
Load paper in the paper
tray
a Pull the paper tray completely out of the
machine.
b While pressing the green paper-guide release
lever a, slide the paper guides to fit the paper
size you are loading in the tray. Make sure that
the guides are firmly in the slots.
c Fan the stack of paper well to avoid paper jams
and misfeeds.
d Put the paper in the tray and make sure:
The paper is below the maximum paper
mark (bbb) a.
Over filling the paper tray will cause paper
jams.
The side to be printed on is face down.
The paper guides touch the sides of the
paper so it will feed correctly.
e Put the paper tray firmly back in the machine.
Make sure that it is completely inserted into the
machine.
f Lift up the support flap a to prevent paper from
sliding off the face-down output tray.