User Manual

Chapter 1
6
1 Fax, Telephone and Copy keys:
 Duplex Copy
Press this key to copy on both sides of the
paper.
 Nin1Copy
Press this key to make N in 1 or Poster
copies.
 Fax Preview
Lets you preview incoming and outgoing
faxes on the LCD.
 Hook
Press before dialling if you want to make
sure a fax machine will answer, and then
press Mono Start or Colour Start.
Also, press this key after picking up the
handset of an external telephone during the
F/T pseudo/double-ring.
 Redial/Pause
Redials one of the last 30 numbers called.
It also inserts a pause when programming
quick dial numbers.
 Paper Setting (MFC-J6510DW)
Press this key to set the paper size or paper
type.
 Tray Setting (MFC-J6710DW)
Press this key to choose the tray you want
to use for printing.
2 Mode keys:
 FAX
Lets you access Fax mode.
 SCAN
Lets you access Scan mode.
 COPY
Lets you access Copy mode.
 PHOTO CAPTURE
Lets you access PhotoCapture Center™
mode.
3 Menu keys:
 Volume keys
d c
While the machine is idle, you can press
these keys to adjust the ring volume.
 Phone Book key
Lets you store, look up, and dial numbers
that are stored in the memory.
 d or c
Press to scroll backward or forward to a
menu selection.
Also, press to choose options.
 a or b
Press to scroll through the menus and
options.
 Menu
Access the main menu.
 Clear
Press to delete characters or to go back to
the previous menu level.
 OK
Lets you confirm a selection.
4 Dial Pad
Use these keys to dial telephone and fax
numbers and as a keyboard for entering
information into the machine.
The # key lets you temporarily switch the
dialling mode during a telephone call from
Pulse to Tone. (Not available in New Zealand)
5
Start keys:
 Mono Start
Lets you start sending faxes or making
copies in monochrome. Also lets you start a
scanning operation (in colour or mono
depending on the scan setting in the
ControlCenter software).
 Colour Start
Lets you start sending faxes or making
copies in full colour. Also lets you start a
scanning operation (in colour or mono,
depending on the scan setting in the
ControlCenter software).
6 Stop/Exit
Stops an operation or exits the menu.