User Manual
Table Of Contents
- BASIC USER’S GUIDE MFC-J6510DW MFC-J6710DW
- User's Guides and where do I find it?
- Table of Contents
- 1 General information
- 2 Loading paper
- 3 Loading documents
- 4 Sending a fax
- 5 Receiving a fax
- 6 Telephone and external devices
- Voice operations
- Telephone Service for Australia
- Telephone Service for New Zealand
- Telephone Service for Some Countries
- Connecting an external TAD (telephone answering device)
- External and extension telephones
- 7 Dialling and storing numbers
- 8 Making copies
- 9 Printing photos from a memory card or USB Flash memory drive
- 10 How to print from a computer
- 11 How to scan to a computer
- A Routine maintenance
- B Troubleshooting
- C Menu and features
- D Specifications
- Index
- brother ARL/ASA/NZ
Loading paper
23
2
Paper Size and Type
(MFC-J6710DW) 2
To get the best print quality, set the machine
for the type of paper you are using.
You can use seven sizes of paper for printing
copies: A4, A5, A3, 10 15 cm, Letter, Legal
and Ledger and five sizes for printing faxes:
A4, A3, Ledger, Letter and Legal. When you
load a different size of paper in the machine,
you will need to change the paper size setting
at the same time so your machine can fit an
incoming fax on the page.
a Press Tray Setting.
b Press a or b to choose Tray#1 or
Tray#2.
Press OK.
c Do one of the following:
If you chose Tray#1, press a or b to
choose Paper Type and press
d or c to choose Plain Paper,
Inkjet Paper, Brother BP71,
Brother BP61, Other Glossy
or Transparency.
Press OK.
Press a or b to choose Paper Size
and press d or c to choose A4, A5,
A3, 10x15cm, Letter, Legal or
Ledger.
Press OK.
If you chose Tray#2, press a or b to
choose Paper Size and press
d or c to choose A4, A3, Letter,
Legal or Ledger.
Press OK.
d Press a or b to choose Complete.
Press OK.
e Press a or b to choose Complete.
Press OK.
Note
• You can only use plain paper and paper
sizes A3, A4, Ledger, Letter or Legal
in Tray#2.
• The machine ejects paper with printed
surfaces face up onto the paper tray in
front of the machine. When you use
transparencies or glossy paper, remove
each sheet at once to prevent smudging
or paper jams.
Tray use in Copy mode
(MFC-J6710DW only) 2
You can change the default tray the machine
will use for printing copies.
Auto Select will allow your machine to
feed paper from either Tray #1 or Tray #2,
using the paper type and size settings from
the COPY key menu.
To change the default setting follow the
instructions below:
a Press Tray Setting.
b Press a or b to choose
Tray Use:Copy.
c Press d or c to choose Tray#1,
Tray#2 or Auto Select.
Press OK.
d Press a or b to choose Complete.
Press OK.
Note
You can change the paper size and tray
selection temporarily for the next copy.
(See Paper Size on page 59 and Tray
Select (MFC-J6710DW only) on page 59.)