Product Safety Guide

ManualsBrandsBrother ManualsComputersAll-in-One Color Laser Printer

Table Of Contents

Product Safety Guide

Read this guide before attempting to operate the product, or before attempting any maintenance.

Failure to follow these instructions may result in an increased risk of personal injury or damage to

property, including through fire, electrical shock, burns, or suffocation. Brother shall not be liable for

damage caused where the product owner has failed to follow the instructions set out in this guide.

Read all of the instructions. Save them for later reference.

Symbols and

Conventions Used in

the Documentation

The following symbols and conventions are

used throughout the documentation.

Follow all warnings and instructions marked

on the product.

WARNING

WARNING indicates a potentially hazardous

situation which, if not avoided, could result in

death or serious injuries.

CAUTION

CAUTION indicates a potentially hazardous

situation which, if not avoided, may result in

minor or moderate injuries.

IMPORTANT

IMPORTANT indicates a potentially

hazardous situation which, if not avoided,

may result in damage to property or loss of

product functionality.

NOTE

NOTE specifies the operating environment,

conditions for installation, or special

conditions of use.

Electrical Hazard icons alert you to

possible electrical shock.

Fire Hazard icons alert you to the

possibility of a fire.

Hot Surface icons warn you not to

touch product parts that are hot.

Prohibition icons indicate actions

that must not be performed.

Bold Bold typeface identifies specific

keys on the product's control

panel or on the computer

screen.

Italics Italicized style emphasizes an

important point or refers you to

a related topic.

Courier

New

Text in Courier New font

identifies messages on the LCD

of the product.

NOTE

• Not all models are available in all countries.

• The illustrations in this guide show the

HL-L8360CDW/HL-L9310CDW/

MFC-L8900CDW.

Product Safety Guide

HL-L8260CDW / HL-L8360CDW / HL-L8360CDWT / HL-L9310CDW /

MFC-L8610CDW / MFC-L8900CDW / MFC-L8895CDW /

MFC-L8905CDW / MFC-L9570CDW

Summary of content (21 pages)

PAGE 1
Product Safety Guide HL-L8260CDW / HL-L8360CDW / HL-L8360CDWT / HL-L9310CDW / MFC-L8610CDW / MFC-L8900CDW / MFC-L8895CDW / MFC-L8905CDW / MFC-L9570CDW Read this guide before attempting to operate the product, or before attempting any maintenance. Failure to follow these instructions may result in an increased risk of personal injury or damage to property, including through fire, electrical shock, burns, or suffocation.
PAGE 2
Compilation and Publication Notice Under the supervision of Brother Industries, Ltd., this product's manuals have been compiled and published, covering the latest product descriptions and specifications. The contents of all manuals and the specifications of this product are subject to change without notice.
PAGE 3
DO NOT place the product near chemicals or in a place where chemicals could be spilled on it. Should chemicals come into contact with the product, there may be a risk of fire or electrical shock. In particular, organic solvents or liquids such as benzene, paint thinner, polish remover, or deodorizer may melt or dissolve the plastic cover and/or cables, resulting in a risk of fire or electrical shock. These or other chemicals may cause the product to malfunction or become discolored.
PAGE 4
CAUTION Put your product on a flat, level, stable surface (such as a desk), that is free from vibration and shocks. Put the product near a telephone wall jack (MFC models only) and a standard grounded AC power outlet. DO NOT place this product on an unstable cart, stand, or table, particularly if children are expected to be near the product. The product is heavy and may fall, causing injury to you or others and serious damage to the product.
PAGE 5
ELECTRICAL HAZARDS Failure to follow the warnings in this section may create the risk of an electrical shock. In addition, you could create an electrical short, which may create the risk of a fire. There are high-voltage electrodes inside the product.
PAGE 6
DO NOT drop any metallic hardware or any type of liquid on the power plug of the product. It may cause an electrical shock or a fire. If water, other liquids, or metal objects get inside the product, immediately unplug the product from the AC power outlet and contact Brother Authorized Service Personnel. This product should be connected to an AC power source within the range indicated on the rating label (You can find the rating label on your machine). DO NOT connect it to a DC power source or inverter.
PAGE 7
FIRE HAZARDS Failure to follow the warnings in this section may create the risk of a fire. DO NOT use flammable substances, any type of spray, or an organic solvent/liquid containing alcohol or ammonia to clean the inside or outside of the product. Doing so could cause a fire. Instead, use only a dry, lint-free cloth. For instructions on how to clean the product, see the Online User's Guide. DO NOT attempt to operate this product when a paper jam or stray pieces of paper are inside the product.
PAGE 8
DO NOT place the following objects on the product. If these objects contact the electrical parts inside the product, it may cause a fire or electrical shock. • Metal objects such as a clip or a staple • Precious metals such as a necklace or a ring • Containers holding water or liquid such as a glass, a flower vase, or a flower pot HOT SURFACE Immediately after using the product, some internal parts of the product will be extremely hot.
PAGE 9
Power Cord Safety: • This product is equipped with a 3-wire grounded plug. This plug will only fit into a grounded power outlet. This is a safety feature. If you are unable to insert the plug into the outlet, call your electrician to replace your obsolete outlet. DO NOT attempt to defeat the purpose of the grounded plug. • DO NOT allow anything to rest on the power cord. • DO NOT place this product where people might step on the cord.
PAGE 10
If you use a Lower Tray, DO NOT carry the product with the Lower Tray, as you may be injured or cause damage to the product because it is not attached to the Lower Tray. (Products with scanning function only) To prevent injuries, be careful not to put your fingers in the areas shown in the illustrations. For your safety, unplug the product from the power outlet when it is not used for a long time.
PAGE 11
Should you come into contact with toner, follow these instructions: • Inhalation Obtain immediate medical attention. In case of accidental inhalation, move to fresh air immediately, then obtain medical attention. • Skin contact Remove contaminated clothing immediately and wash affected skin with plenty of water or soap and water. • Eye contact Obtain medical attention. If the toner has gotten into the eyes, immediately wash out the eyes with water continuously, for at least 15 minutes.
PAGE 12
Important Safety Instructions DO NOT attempt to service this product yourself because opening or removing covers may expose you to dangerous voltage points and other risks and may void your warranty. Refer all servicing to a Brother Authorized Service Center. 1. Read all of these instructions. 2. Save these instructions for later reference. 3. Follow all warnings and instructions marked on the product. 4.
PAGE 13
(MFC models only) To reduce the risk of fire, electrical shock, and injury to people; • Use only a No. 26 AWG or larger telecommunication line cord. Disconnect device This product must be installed near an AC power outlet that is easily accessible. In case of an emergency, you must unplug the power cord from the AC power outlet to shut off the power completely. IMPORTANT This product has been certified to comply with FCC standards, which are applied to the USA only.
PAGE 14
If this equipment causes harm to the telephone network, the telephone company will notify you in advance that temporary discontinuance of service may be required. But if advance notice is not practical, the telephone company will notify you as soon as possible. Also, you will be advised of your right to file a complaint with the FCC if you believe it is necessary. The telephone company may make changes in its facilities, equipment, operations, or procedures that could affect the operation of the equipment.
PAGE 15
Federal Communications Commission (FCC) Declaration of Conformity (USA Only) Responsible Party: Brother International Corporation 200 Crossing Boulevard Bridgewater, NJ 08807-0911 USA TEL: (908) 704-1700 declares, that the products Product Name: Color Laser Printer Model Numbers: HL-L8260CDW/HL-L8360CDW/HL-L8360CDWT/HL-L9310CDW Product Name: Multi Function Printer Model Numbers: MFC-L8610CDW/MFC-L8900CDW/MFC-L8895CDW/MFC-L8905CDW/ MFC-L9570CDW comply with Part 15 of the FCC Rules.
PAGE 16
RF Exposure Notice (USA or Canada Only) (Wireless Models Only) This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines and RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment should be installed and operated keeping the radiator at least 20 cm or more away from a person's body.
PAGE 17
The Ringer Equivalence Number (REN) indicates the maximum number of devices allowed to be connected to a telephone interface. The termination of an interface may consist of any combination of devices subject only to the requirement that the sum of the RENs of all the devices not exceed five. L'indice d'équivalence de la sonnerie (IES) sert à indiquer le nombre maximal de dispositifs qui peuvent être raccordés à une interface téléphonique.
PAGE 18
For Use in the USA or Canada Only These products are made for use in the USA and Canada only. We cannot recommend using them overseas because it may violate the Telecommunications Regulations (MFC models only) of that country and the power requirements of your product may not be compatible with the power available in foreign countries. Using USA or Canada models overseas is at your own risk and may void your warranty.
PAGE 19
Android is a trademark of Google Inc. Google Play is a trademark of Google Inc. Each company whose software title is mentioned in this manual has a Software License Agreement specific to its proprietary programs. Software Trademarks FlashFX® is a registered trademark of Datalight, Inc. FlashFX® Pro™ is a trademark of Datalight, Inc. FlashFX® Tera™ is a trademark of Datalight, Inc. Reliance™ is a trademark of Datalight, Inc. Reliance Nitro™ is a trademark of Datalight, Inc.
PAGE 20
The listing below is intended to be a guide rather than a complete listing of every possible prohibition. In case of doubt, we suggest that you consult with the appropriate authority or advisor with regard to the specific document. The following documents issued by the United States/Canadian Government or any of its Agencies, States, Territories, or Provinces may not be copied.
PAGE 21
These machines are approved for use in the country of purchase only. Local Brother companies or their dealers will support only machines purchased in their own countries.