User Manual
Table Of Contents
- Product Safety Guide
- Symbols and Conventions Used in the Documentation
- Compilation and Publication Notice
- Choose a Safe Location for Your Product
- Connect the Product Safely
- Use the Product Safely
- Product Warranty & Liability
- Approval Information (MFC Models Only)
- Wiring Information (U.K. Only)
- Declaration of Conformity (Europe Only)
- UK Declaration of Conformity for Radio Equipment Regulation 2017 (Great Britain Only) (Applicable to Models with Radio Interfaces)
- EU Declaration of Conformity for RE Directive 2014/53/EU (Europe Only) (Applicable to Models with Radio Interfaces)
- IEC60825-1:2014 Specification (For 220-240V Models Only)
- Wireless LAN (Models with Wireless LAN Function Only)
- NFC (Models with NFC Function Only)
- LAN Connection (Models with Wired LAN Function Only)
- Recycling Information in Accordance with the WEEE and Battery Directives
- Imaging Equipment Voluntary Agreement
- Trademarks
- Open Source Licensing Remarks
- Copyright and License
- Brother Customer Service
- Unlawful Use of Copying Equipment (Products with scanning function only)
Choose a Safe Location for Your Product
WARNING
Choose a location where the temperature remains between 10°C and 32°C, the humidity is
between 20% and 80%, and where there is no condensation.
DO NOT place the product near heaters, air conditioners, electrical fans, refrigerators, or
water. Doing so may create the risk of an electrical shock, short circuit, or fire, as water may
come into contact with the product (including condensation caused by heating/air
conditioning/ventilation equipment).
DO NOT expose the product to direct sunlight, excessive heat, open flames, corrosive
gasses, moisture, or dust. Doing so may create a risk of an electrical shock, short circuit, or
fire, causing damage to the product and/or rendering it inoperable.
DO NOT place the product near chemicals or in a place where chemicals could be spilled on
it. Should chemicals come into contact with the product, there may be a risk of fire or electrical
shock. In particular, organic solvents or liquids such as benzene, paint thinner, polish remover,
or deodoriser may melt or dissolve the plastic cover and/or cables, resulting in a risk of fire or
electrical shock. These or other chemicals may cause the product to malfunction or become
discoloured.
3