User Manual
Table Of Contents
- User’s Guide P300BT
- Safety Precautions
- General Precautions
- Performing Routine Maintenance
- Accessories
- Specifications
- Important Information
- Unpacking the P300BT
- 1. Parts and Components
- 2. Installing Batteries or Connecting the AC Adapter
- 3. Inserting the Tape Cassette
- 4. Turning Your Machine On or Off
- 5. LED Indications
- 6. Pairing Your Machine with Your Mobile Device
- 7. Troubleshooting
This label printer requires six (6) AAA alkaline batteries or six (6) fully-charged AAA
Ni-MH batteries, not included. As an alternative, use the optional AC Adapter and plug your
machine into an AC socket.
2. Installing Batteries or Connecting the AC Adapter
1. Hold your machine as shown in the
illustration. Open the Battery Cover
by pressing the mark on its side (1)
and pulling in the direction of the
arrow (2).
2. Insert six batteries as shown in the
illustration inside the case. Alternate
the positive and negative poles,
making sure the negative poles touch
the coil spring in the battery slot.
3. Insert the two hooks at the rear of the
Battery Cover into the slots on your
machine (3). Push the Battery Cover
(4), making sure it locks into place.
2
1
The coils are
negative pole
4
3