User's Guide
Table Of Contents
- User’s Guide RJ-2030/RJ-2050/RJ-2140/RJ-2150
- Introduction
- IMPORTANT NOTE
- Table of Contents
- Section I: Basic Operations
- 1 Setting Up the Printer
- General Description
- Battery Installation/Removal
- Recharging the Battery
- Turning the Printer On or Off
- Setting the Language of the LCD
- Inserting the Paper or Label Roll
- Removing the Receipt/Label Roll
- Attaching the Belt Clip
- Install Software to Your Computer or Mobile Device
- Connecting the Printer to a Computer or Mobile Device
- LCD
- 2 Using the Printer
- 3 Changing the Printer Settings
- 4 Other Functions
- 5 Maintaining the Printer
- 1 Setting Up the Printer
- Section II: Application
- Section III: Wireless network (RJ-2050/2140/2150 Only)
- Section IV: Appendix
Changing Your Printer’s Network Settings
118
11
3 Double-click the new, unconfigured device.
Note
If you do not use a DHCP/BOOTP/RARP server, the device appears as [Unconfigured] in the BRAdmin
Light utility screen.
4 Select [STATIC] for the [Boot Method]. Enter the [IP Address], [Subnet Mask] and [Gateway] (if
needed) of your print server.
5 Click [OK].
6 With a correctly programmed IP address, the Brother print server appears in the device list.