User's Guide
Table Of Contents
- User’s Guide RJ-2030/RJ-2050/RJ-2140/RJ-2150
- Introduction
- IMPORTANT NOTE
- Table of Contents
- Section I: Basic Operations
- 1 Setting Up the Printer
- General Description
- Battery Installation/Removal
- Recharging the Battery
- Turning the Printer On or Off
- Setting the Language of the LCD
- Inserting the Paper or Label Roll
- Removing the Receipt/Label Roll
- Attaching the Belt Clip
- Install Software to Your Computer or Mobile Device
- Connecting the Printer to a Computer or Mobile Device
- LCD
- 2 Using the Printer
- 3 Changing the Printer Settings
- 4 Other Functions
- 5 Maintaining the Printer
- 1 Setting Up the Printer
- Section II: Application
- Section III: Wireless network (RJ-2050/2140/2150 Only)
- Section IV: Appendix
Setting Up the Printer
15
1
3 While lifting the roll guide adjustment lever, push in both roll guides to the roll width. Insert the media roll
so that it is positioned straight in the media roll compartment.
4 Close the media roll compartment by pressing down on the center of the cover until it locks into place.
Note
When using die-cut label (RJ-2140/2150 only), press the (Feed) button after inserting the media roll.
The printer will adjust the label to the correct starting position.
Important
Use genuine Brother media.