User's Guide
Table Of Contents
- User’s Guide RJ-2030/RJ-2050/RJ-2140/RJ-2150
- Introduction
- IMPORTANT NOTE
- Table of Contents
- Section I: Basic Operations
- 1 Setting Up the Printer
- General Description
- Battery Installation/Removal
- Recharging the Battery
- Turning the Printer On or Off
- Setting the Language of the LCD
- Inserting the Paper or Label Roll
- Removing the Receipt/Label Roll
- Attaching the Belt Clip
- Install Software to Your Computer or Mobile Device
- Connecting the Printer to a Computer or Mobile Device
- LCD
- 2 Using the Printer
- 3 Changing the Printer Settings
- 4 Other Functions
- 5 Maintaining the Printer
- 1 Setting Up the Printer
- Section II: Application
- Section III: Wireless network (RJ-2050/2140/2150 Only)
- Section IV: Appendix
Changing the Printer Settings
48
3
Communication Modes and Authentication Methods/Encryption Modes 3
When [Communication Mode] is set to [Ad-hoc]
When [Communication Mode] is set to [Infrastructure]
Important
To specify higher level security settings:
When performing certificate verification with EAP-FAST, PEAP, EAP-TTLS or EAP-TLS authentication
methods, the certificate cannot be specified from the Printer Setting Tool. After the printer is configured to
connect to the network, specify the certificate by accessing the printer from a web browser.
For more information on using a web browser, see Web Based Management on page 120.
Authentication Method Encryption Mode
Open System None / WEP
Authentication Method Encryption Mode
Open System None / WEP
Shared Key WEP
WPA/WPA2-PSK TKIP+AES / AES
LEAP CKIP
EAP-FAST/NONE TKIP+AES / AES
EAP-FAST/MS-CHAPv2 TKIP+AES / AES
EAP-FAST/GTC TKIP+AES / AES
PEAP/MS-CHAPv2 TKIP+AES / AES
PEAP/GTC TKIP+AES / AES
EAP-TTLS/CHAP TKIP+AES / AES
EAP-TTLS/MS-CHAP TKIP+AES / AES
EAP-TTLS/MS-CHAPv2 TKIP+AES / AES
EAP-TTLS/PAP TKIP+AES / AES
EAP-TLS TKIP+AES / AES