User's Guide
Table Of Contents
- User’s Guide RJ-2030/RJ-2050/RJ-2140/RJ-2150
- Introduction
- IMPORTANT NOTE
- Table of Contents
- Section I: Basic Operations
- 1 Setting Up the Printer
- General Description
- Battery Installation/Removal
- Recharging the Battery
- Turning the Printer On or Off
- Setting the Language of the LCD
- Inserting the Paper or Label Roll
- Removing the Receipt/Label Roll
- Attaching the Belt Clip
- Install Software to Your Computer or Mobile Device
- Connecting the Printer to a Computer or Mobile Device
- LCD
- 2 Using the Printer
- 3 Changing the Printer Settings
- 4 Other Functions
- 5 Maintaining the Printer
- 1 Setting Up the Printer
- Section II: Application
- Section III: Wireless network (RJ-2050/2140/2150 Only)
- Section IV: Appendix
Changing the Printer Settings
58
3
Advanced Tab 3
1 Feed Key Function
Select the operation that is performed when the (Feed) button is pressed.
If [Program Settings] is selected, click the [File] button and select the command file.
Available settings: [Feed], [Program Settings]
2 Printer Information Report
Select which sections are printed when printing the printer setup information.
Available settings: [All], [Usage Log], [Printer Settings], [Printer Transfer Data]
(See Printing the Printer Information on page 71)
3 Beeper
Select whether the printer beeps when an operation panel button is pressed.
Available settings: [On], [Off]
4 Serialize Mode
Select whether or not to serialize from the last number printed.
Available settings: [Cont From Last], [From Starting#]
5 Save Printer Print Log
Select whether or not to save the printer’s print log. If [Disable] is selected, [Tools]- [Save Print Log in
File] cannot be enabled.
Available settings: [Enable], [Disable]
6 Print Data after Printing
Select whether or not print data is erased automatically after it is printed.
Available settings: [Erase All Print Data], [Keep Print Data]
7 Airplane Mode
Allows disabling the Bluetooth or Wi-Fi connection. This function is useful when you use the printer in a
place where signal transmissions are not allowed.
Available settings: [On], [Off]
1
2
3
4
5
6
7