Owner's Manual

To place the gun
“ON SAFE,” press
the safety button
to the right.
To move the
safety to the FIRE
position, press the
safety to the left
(Figure 2-A).
The safety is reversible and can be reversed from right- to left-handed
by a competent gunsmith. When installed, the left-handed safety will
have the safety button’s red warning band on the RIGHT side of the
trigger guard.
NOTE: DO NOT DEPEND ON THE RED COLOR ALONE TO INDICATE YOUR
GUN’S SAFETY STATUS, AS TIME, EXPOSURE TO THE ELEMENTS, AND THE
ABRASIVE ACTION OF CLEANING AGENTS CAN ERASE IT.
HOW TO ASSEMBLE THE BARREL TO
THE RECEIVER
The Gold Fusion shotgun is delivered in the box, with the barrel
removed and the forearm still attached to the magazine tube. It is
important to follow the exact sequence for assembly in steps 1 and
2, in order to properly assemble your Fusion shotgun.
Always place the safety in the “on safe” position before assembly
procedures and check your gun carefully to be certain that the
chamber, feed mechanism and magazine contain no shells.
1 Take the receiver in hand. First, lock the bolt rearward by pulling
the operating handle fully to the rear. Remove the forearm from the
magazine tube by unscrewing the magazine cap and sliding the
forearm forward, off the magazine tube.
Do not squeeze hard on the open rear end of the forearm. Too much
pressure could cause the wood to split.
11
FIGURE 2
FIGURE 2-A
00479BFA/Fusion OM 8/11/03 3:54 PM Page 11