Owner's Manual

disassembly involves removal of

the bolt assembly and the trigger

group. Any disassembly beyond

this should only be performed by

a competent gunsmith.

ALWAYS WEAR EYE PROTECTION

WHEN PERFORMING ANY MAINTE-

NANCE OR DISASSEMBLY.

REMOVING THE

TRIGGER GROUP

1 First, make certain the gun is

totally unloaded and the “safety”

is “on safe.” CHECK THE MAGAZINE, FEED MECHANISM

AND CHAMBER TO BE SURE THEY DO NOT CONTAIN

ANY SHELLS.

2 While holding the bolt handle, release the bolt to its forward position

by depressing the carrier release button. Again use caution when

releasing the bolt assembly to its forward position. If you allow the

bolt assembly to slam closed with the barrel removed, you can

damage the receiver.

FIGURE 4-A

Push the trigger guard pins through the other

side of the receiver.

FIGURE 4-B

Grasp the trigger guard and pull it up and out of

the receiver.

FIGURE 4

Use a drive punch to push Inward on the

trigger guard pins.

00479BFA/Fusion OM 8/11/03 3:55 PM Page 14