Owner's Manual

3 Use a drive punch or similar object to push inward on the trigger
guard pins, using caution not to scratch the receiver (Figure 4).
Trigger guard pins may be removed from either side of the receiver.
Push the trigger guard pins clear through the other side of the
receiver. It may be necessary to pull on the trigger pins to remove
them from the receiver (Figure 4-A).
4 Grasp the trigger guard and pull it up and out of the receiver(Figure
4-B).
5 Perform any cleaning of the parts and receiver cavity as necessary.
DO NOT DISASSEMBLE THE TRIGGER GROUP BEYOND THIS POINT.
REASSEMBLY
1 Make sure the bolt is in the forward position.
2 Insert the trigger group back into the receiver. The holes in the trigger
group should line up with the holes on each side of the receiver.
3 Reinsert the trigger guard pins and gently tap them into place with
a plastic or wooden mallet, again using caution not to scratch the
receiver.
REMOVING THE BOLT ASSEMBLY
To remove the bolt assembly it is preferred to first remove the trigger
group, as explained previously.
1 With the gun inverted (trigger
guard up position), push down
on the cartridge stop while
pulling outward on the bolt
handle (Figure 5). Remove the
bolt handle from the bolt.
2 While keeping the cartridge stop
depressed, slide the bolt and bolt
slide forward and out of the
receiver (Figure 5-A).
3 The bolt and bolt slide can be
15
FIGURE 5
Push down on the cartridge stop while pulling
outward on the bolt handle.
00479BFA/Fusion OM 8/11/03 3:55 PM Page 15