Owner's Manual

separated for cleaning (Figure 5-B). Perform any cleaning of the bolt
and receiver cavity as necessary.
DO NOT DISASSEMBLE THE BOLT ASSEMBLY BEYOND THIS POINT.
REINSTALLING THE BOLT ASSEMBLY
1 Reassemble the bolt and bolt slide.
2 Place the bolt assembly back in the receiver, bolt slide link end
first (Figure 5-C). Line the rails on the bolt slide with the slots
in the bottom of the receiver.
3 Guide the bolt slide link into its socket in the recoil spring follower
(Figure 5-D).
4 To replace the operating handle push down on the cartridge stop and
insert the bolt handle in its respective slot in the bolt. IMPORTANT:
It may be necessary to pull out on the bolt handle slightly until the
cartridge stop clicks back in place (Figure 5-E). Failure to follow these
instructions will result in the inability to load the magazine.
5 Open and close the action several times to make sure the bolt slide
link and recoil spring follower are properly engaged.
16
FIGURE 5-B
The bolt and bolt slide can be
separated for cleaning.
FIGURE 5-A
Slide the bolt and bolt slide
forward and out of the receiver.
00479BFA/Fusion OM 8/11/03 3:55 PM Page 16