Owner's Manual

compliance with SAAMI specifications) including magnum lead
and steel shot loads and rifled slug loads. Browning’s universal tube
wrench is used to remove and install these tubes.
12 GAUGE INVECTOR-PLUS
The 12 gauge Gold Fusion shotgun has a back-bored barrel and is
threaded to accept Invector-Plus choke tubes only. They are not
interchangeable with 12 gauge Standard Invector choke tubes. Do
not use Invector-Plus tubes in barrels threaded for Standard Invector
tubes. Do not use Standard Invector tubes in barrels threaded for
Invector-Plus tubes. Failure to follow these warnings may damage your
gun and cause injury to yourself and others. A special “Plus” choke tube
wrench is provided to remove and tighten Invector-Plus choke tubes.
DO NOT FIRE THE GOLD FUSION SHOTGUN WITHOUT HAVING AN
INVECTOR-PLUS CHOKE TUBE INSTALLED.
Permanent damage may
result to the threads.
DO NOT USE BROWNING INVECTOR OR INVECTOR-PLUS CHOKE TUBES
IN ANY SHOTGUN BARREL NOT SUPPLIED BY BROWNING. ALSO, DO NOT
USE ANY OTHER BRAND OF CHOKING DEVICE IN ANY SHOTGUN BARREL
SUPPLIED BY BROWNING. USE ONLY CHOKE TUBES MARKED INVECTOR
OR INVECTOR-PLUS
CAUTION: WHENEVER HANDLING ANY SHOTGUN FOR THE PURPOSE OF
REMOVING OR INSTALLING A CHOKING DEVICE, MAKE ABSOLUTELY
CERTAIN THE GUN IS COMPLETELY UNLOADED, AND THE BOLT OR BREECH
IS OPEN! NEVER ATTEMPT TO REMOVE OR INSTALL A SHOTGUN CHOKING
DEVICE ON A LOADED FIREARM!
TUBE REMOVAL
1 Place the “safety” in the “on safe” position. Completely unload your
Gold fusion by opening the action and locking it rearward. INSPECT
THE CHAMBER, FEED MECHANISM AND MAGAZINE TO
MAKE SURE THEY DO NOT CONTAIN ANY SHELLS.
2 Use the Invector wrench to loosen the tube, turning it counter-
clockwise. Finger twist the tube the rest of the way out of the barrel.
25
00479BFA/Fusion OM 8/11/03 3:55 PM Page 25