MSDS

MATERIAL SAFETY DATA SHEET
I. PRODUCT IDENTIFICATION
Name: Armstrong Wood Filler Stick
Description: Wood Filler Stick
II. DEPARTMENT OF TRANSPORTATION INFORMATION
Shipping name: Not Restricted Hazard Class: N/A
ID #: N/A Packing Inst.: N/A DOT/IMO/IATA: N/A
EMERGENCY ONLY CONTACT: CHEM-TEL [phone]
III. HMIS (0=minimal hazard; 4 = severe hazard)
Health = 1 Flammability = 1 Reactivity = 0
IV. PRODUCT CONTENT
This product contains does not contain materials which are subject to the
reporting requirements of Section 313 of SARA Title III and 40 CFR 372. All
components are on TSCA inventory.
V. HAZARDOUS INGREDIENTS
(Chemical Identity; Common Name) C.A.S. No. % OSHA PEL ACGIH TLV
Wax 63231-60-7 30-50
Polyethylene Wax 8002-74-2 30-50
Stearic Acid 57-11-4 1309-37-1
Iron Oxide 1309-37-2 1-10
Cetyl Alcohol 36653-82-4 1-10
Stearyl Alcohol 112-92-5 1-10 100 ppm 100 ppm
Myristic Alcohol 112-72-1 <1 25 ppm 1 ppm
Carbon Black 1333-86-4 <0.1 50 ppm 25 ppm
VI. PHYSICAL DATA
APPEARANCE AND COLOR: Solid. ODOR: Mild. BOILING
RANGE (degrees F): N/A. VAPOR PRESSURE: N/A. VAPOR
DENSITY: N/A. SOLUBILITY IN WATER: N/A. SPECIFIC
GRAVITY: 0.95. EVAPORATION RATE: N/A. pH: N/A.
VII. FIRE AND EXPLOSION HAZARD DATA
FLASH POINT: Will not flash. FLAMMABILITY RANGE: N/A.
AUTOIGNITION TEMPERATURE: N/A. EXTINGUISHING
MEDIA: Alcohol foam, dry chemical, carbon dioxide. SPECIAL
FIRE FIGHTING ROCEDURES: Protect fire fighters from toxic
products of combustion by wearing self-contained breathing
apparatus. UNUSUAL FIRE AND EXPLOSION HAZARDS:
None..
VIII. HEALTH HAZARD DATA
PRIMARY ROUTES OF ENTRY: Skin contact, eye contact,
inhalation. EYE CONTACT: May cause irritation to eyes.
SKIN CONTACT: May cause irritation to skin. INHALATION:
N/A.. CARCINOGENICITY: NTP: No. IARC Monographs: No.
OSHA Regulated: No. FIRST AID PROCEDURES: EYES:
Upon eye contact, flush eyes with plenty of water for at least
15 minutes. Get medical attention if symptoms persist. SKIN:
Upon skin contact, wash with soap and water. Get medical
attention if symptoms persist. INHALATION: N/A.
INGESTION: Do not induce vomiting, call a physician
immediately.
IX. REACTIVITY DATA
STABILITY: Stable under normal storage conditions.
INCOMPATIBILITY: None. HAZARDOUS
DECOMPOSITION PRODUCTS: Carbon monoxide, carbon
dioxide. HAZARDOUS POLYMERIZATION: Will not occur.
X. SPILL OR LEAK PROCEDURES
SPILLS: N/A. WASTE DISPOSAL METHOD: Dispose of
container and any unused contents in accordance with
Federal, State and Local Waste Disposal Regulations. Do not
flush unused contents or residue down drains.
XI. SPECIAL HANDLING AND USE INFORMATION
VENTILATION: Use with adequate ventilation. Use local
exhaust to insure that vapor levels are below the lowest
component TLV. RESPIRATORY PROTECTION: Not
normally needed, if there is not adequate ventilation, use with a
NIOSH approved vapor cartridge respirator. SKIN AND EYE
PROTECTION: It is always a good safety practice to avoid
contact with eyes and skin. If contact may occur, use chemical
splash goggles and latex or rubber gloves.
XII. SPECIAL PRECAUTIONS
PRECAUTIONS TO BE TAKEN IN HANDLING AND
STORAGE: Do not store in excessive heat above 120F. Keep
away from heat and flame. Keep container closed when not in
use. KEEP OUT OF REACH OF CHILDREN. OTHER
PRECAUTIONS: None. WORK SITE ENVIRONMENT: Initially
there may be a potential adverse impact on indoor air quality
within the general work area during the installation process.
Therefore you should advise the building manager or other
appropriate person that:
• It will be necessary to establish and maintain adequate
ventilation of the work area, without causing the entry of
contaminants to other parts of the building; and • Persons who
are sensitive to odors and/or chemicals should be advised to
avoid the work area during this process.
The information presented herein is supplied as a guide to
those who handle or use this product. Safe work practices
must be employed when working with any materials. It is
important that the end user makes a determination regarding
the adequacy of the safety procedures employed during the
use of this product.
N/A - not applicable or not available
N/K - none known or not known
Filler Stick
Prepared 01/10
Armstrong World Industries, Inc.
P. O. Box 3001
Lancaster, PA 17604
Technical Services:
1-877-276-7876, Option 2,3,3