Instructions

ManualsBrandsBrüder Mannesmann ManualsCordless DrillBrüder Mannesmann M17640 Cordless drill 20 V 1.5 Ah Li-ion incl. spare battery, incl. case

GB - 8

Cordless drill

Item no. 17640

Operating instructions

Please read and act upon the enclosed safety instructions before operating

electrical tools!

Intended use

The battery powered drill is intended for:

 Drilling in wood, metal and plastic

 Inserting and removing nuts and screws

Additional safety instructions for battery powered drills

 Before working on a component, ensure that the component is held down using a vice or

fastening clamp.

 Do not use excessive pressure, but instead select an appropriate speed. Excessive pressure

will not increase drilling efficiency, and may damage your appliance.

 Set the rotation direction switch to its central position when machine not in use in order to

avoid accidental operation.

 Only use the battery charger in closed rooms and do not expose this to rain or humidity.

 When inserting the batteries into the battery charger, ensure that the correct polarity is used.

 Do not use a battery charger whose power lead is damaged. Always replace or repair this.

 In the event of damage being apparent to the battery charger housing, have this examined

by a specialised repair shop and if necessary replaced.

 Always wear protective eyewear and ear protectors when working. A dust mask

should be worn during any dust-producing work.

Specification (Fig. 1)

1. Keyless drill chuck

2. Adjustable ring for torque / boring

3. 1 / 2-way operating switch

4. Left / right-hand motion changeover switch

5. Operating button

6. Battery pack

7. Battery attachment clip

8. Working spot light

9. Loading socket

10. Plug adaptor

Summary of content (5 pages)

PAGE 1
Cordless drill Item no. 17640 Operating instructions Please read and act upon the enclosed safety instructions before operating electrical tools! Intended use The battery powered drill is intended for:   Drilling in wood, metal and plastic Inserting and removing nuts and screws Additional safety instructions for battery powered drills        Before working on a component, ensure that the component is held down using a vice or fastening clamp.
PAGE 2
Technical data Battery powered drill: Voltage Rotation speed, Setting 1. Rotation speed, Setting 2.
PAGE 3
 The battery set is completely loaded and ready for use once the green LED is lit and the red LED is OFF – after approximately one hour. Defective or used battery sets must be disposed of in specialised refuse, and must not be placed in domestic refuse. Keyless drill chuck The keyless drill chuck (1) allows the clamping of drill bits or other tools without the use of a drill chuck key.
PAGE 4
See below to select the appropriate rotation speed:  Low rotation speed (Setting 1) is for drilling into non pre-worked materials, for screwing, mixing paints, or for drilling into ceramics.  The high rotation speed (Setting 2) is for drilling into metal and plastic. Torque settings The battery powered drill is fitted with a torque setting.  Rotate the ring (2) to adjust the torque, to achieve different screw thread projections. The higher the adjustment number, the higher the torque.
PAGE 5
Obsolete Electrical Appliances and Environmental Protection     If your electrical power tool has been used so intensively on a daily basis that it must be replaced, or if you have no further use for it, you are required to dispose of the electrical appliance at a central recycling point. Information on recycling centers for your electrical appliances can be obtained from your local waste disposal companies and/or your local government offices.