Instructions

GB - 9
Technical data
Battery powered drill:
Voltage 20 V DC
Rotation speed, Setting 1. 0 – 400 min
-1
Rotation speed, Setting 2. 0 – 1,400 min
-1
Drill chuck 10 mm
Sound pressure level (LPA) 87,6 dB (A)
(Uncertainty K = 3 dB)
Sound power level (LWA) 98,6 dB (A)
(Uncertainty K = 3 dB)
Vibration drilling 1,298 m/s²
(Uncertainty K = 1,5 m/s²)
It is recommended that safety goggles, ear protectors and a face mask are worn during
drilling!
Batteries: Voltage 20 V DC, 1500 mAh
Charging time abt. 1 hour
Charging unit : Pri: 100-240 V AC/ 50-60 Hz
Sec: 21,5 V DC / 1,5 A
Noise and vibration information
Measured values determined according EN 60745
- The vibration emission level given in this information sheet has been measured in accor-
dance with a standardised test given in EN 60745 and may be used to compare one tool
with another.
- The vibration emission level will vary because of the ways in which a power tool can be used
and may increase above the level given in this information sheet.
- Try to keep the exposure as low as possible. To reduce the vibration emission level the user
should wear working-gloves and use the machine for limited time.
-
All parts of working cycles have to be considered ( including the time the power tool is
switched off, and the time, when the power tool is running under no-load condition).
Charging procedure
 Before their first use, the battery set (6) must be loaded.
 Only use the provided adaptor (10) to charge the battery set.
 Only charge the battery set when the ambient temperature is within 10° - 40° C.
 Plug the adaptor (10) to a 230V alternating voltage source.
 The battery set (6) should under no circumstances be disassembled.
 To remove the battery set, press the attachment clip (7) on the top side of the battery set
and extract the battery set (6).
 Connect the plug of the charger to the loading-socket (9) of the battery-set.
 Red LED will light once the battery has been connected to the charger and the charging
procedure will proceed.