Instructions
GB - 10
The battery set is completely loaded and ready for use once the green LED is lit and the red
LED is OFF – after approximately one hour.
Defective or used battery sets must be disposed of in specialised refuse, and
must not be placed in domestic refuse.
Keyless drill chuck
The keyless drill chuck (1) allows the clamping of drill bits or other tools without the use of a drill
chuck key.
Before inserting a drill bit or other tool, the rotation direction switch (4) must be switched to
its central position.
Rotate the front section of the drill chuck (1) to the right to open the jaws until the tool can be
inserted.
Insert the drill bit or the tool as far as it will go into the drill chuck.
To close the drill chuck, rotate the front section to the left to close the jaws.
Ensure that the drill bit or tool is seated correctly and centrally as you close the drill chuck.
Working spot light
Pushing the operating button (5) will turn on the working spot light (8).
Leaving the operating button (5) will switch off the working spot light (8).
Left / right motion direction
The rotation direction of the drill chuck (1) can be changed using the rotation direction switch
(4).
To change the direction of rotation, stop the machine and turn the switch (4) in the desired
direction.
The central position of the switch (4) locks the operating button (5).
Do not change the direction of rotation of the machine, when it is operating!
Before beginning to work, check that the rotation direction switch (4) is in the desired
position in order to avoid potential damage to the tool or to the battery powered drill.
Drilling
When drilling into metal, wood or plastic, the adjustable ring (2) should be adjusted so that
the drill symbol indicates the appropriate marking on the housing.
Revolutions pre-selection
The machine is fitted with a switch (3) to select two rotation speed settings.
The first setting sets the machine rotation speed between 0 - 400 min
-1.
The second setting sets the machine rotation speed between 0 - 1.400 min
-1
.
Do not change the speed during operation of the machine.