Use and Care Manual

36BB, 36BDB

BRUSH BEAST

Rev: Mar2011

BRUSH BEAST Brush Mower

Lubrication Points

To ensure proper lubrication of moving parts, GXi recommends that you lubricate the following components with a high-

quality, EP2 high-temperature-based grease or equivalent. Should the conditions of operation be more severe than

normal, the lubrication interval may need to be shortened. GTR/OPE grease is the recommended lubricant.

Lubrication Point Locations

BRUSH BEAST mowers have four (4) lubrication points.

Note: The brush mower spindle bearings are both

sealed top and bottom to prevent contaminants from

entering the spindle. There is no service point on the

spindle.

Lubricate after every 50 hours of usage

Mower deck idler pulley

brackets (1 location)

2. Blade activation rod supports (2 locations: one at

the support under the fuel tank bracket and one

adjacent to the engine.)

3. Hydraulic drive

system idler

puller support (1

location)

Note: Be sure the hydro unit is disengaged (see page 11)

before interchanging the optional attachment deck.

1. Remove the deck cover

by releasing the three

(3) T-handles.

2. Disconnect the

clutch tension rod

connecting the deck

to the chassis.

Deck Interchange

3. Remove the belt from

the engine pulley.

4. Using an 18 mm

wrench or socket,

remove the four (4)

deck retaining bolts.

5. Tilt handle bars forward and pull chassis from deck.

6. Reverse the steps to reconnect the optional

attachment deck. Refer to the owner manual

supplied with the optional deck for assembly and

operation instructions.