Use and Care Manual

Rev: 10/2015
 Brush Master™ Chipper/Shredder with 2-Way Feed
3
Heavy Duty Power Equipment
Component Identification
Recoil Starter
The starter handle is located on
the engine. Pull the starter
handle to start engine.
Chipper Funnel
Use the chipper funnel to
feed leaves only.
Chipper Chute
Use the chipper chute to feed
longer and/or thicker pieces of yard
waste into the impeller for
chipping. Depending on the model
#, the chipper/shredder can cut up
to a 3” x 4” in diameter piece of
wood.
Lawn Tractor or ATV Hitch
Use this hitch to tow the chipper/shredder behind a lawn
tractor or ATV (maximum tow speed is 15 mph).
Discharge Chute
Chipped materials are
discharged through this
opening. It may be left open or
the chipper collection bag can
be attached to the chute.
Fuel Tank
Use regular unleaded fuel. Always
leave about 1” of air gap at the top of
the tank for fuel expansion to prevent
seepage or spills.
Blade Access Hatch
Remove the blade access
hatch to clean, remove, or
sharpen the chipper/shredder
blade.
Hardware Bag
This bag contains the assembly hardware, safety devices
and chipper collection bag. Use the chipper bag to collect
shredded or chipped material fed through the chipper chute
or hopper assembly.
On/Off Switch
Set this switch to On before
using recoil starter. Set switch
to Off to switch off engine.
Choke Lever
Move the choke lever to the
CHOKE position to prepare a
cold engine for starting.
Fuel Valve
Use the fuel valve to turn
fuel on and off to engine.
If you are missing any parts, please complete the form on the next page and fax it back to us at: 919-550-3277.
Serial #:
Stamped on engine block
between funnel and engine
Red Electric Start Push
Button
120V Outdoor Extension
Cord Connection (Plug
in for 120V electric start)