Form No. 4002 (Rev.
Save energy and reduce Condensate Transfer Stations 6 to 60 GPM pump capacities 10 to 60 PSI discharge pressures 8 to 50 gallon receivers Model B-26S-D In most heating systems, condensate, and sometimes steam, is trapped out of heaters, kettles, hot presses, molds, absorbers, and other equipment and drained to a return unit having given up some of its heat in the process. If a trap malfunctions, the condensate can be passed to the return unit at a much higher temperature causing the return unit to fail.
operating cost by re-using condensate Compact Boiler Feed Systems Capacities from 20 to 80 boiler HP 15 through 150 PSI boilers The Bryan compact boiler feed system requires a minimal amount of boiler room space while providing many of the same rugged features as competitive stand-mounted feed systems.
Reduce costs/improve efficie Spray Type and Tray Type Deaerator Features • Constructed and Stamped to ASME Section VIII, Division 1 for 50 psig • 1/16" corrosion allowance • Easily accessible manway • 10 minutes of deaerated water storage to overflow • All internal surfaces that contact undeaerated water are constructed of stainless steel • 2-stage deaeration • Structural steel stand/pump platform • Available as completely packaged unit including pumps and control panel Why deaerate boiler feedwater? There
ency by pre-heating/deaerating boiler feed water Pressurized Tray Type Deaerator Capacities from 5,000 pph - 300,000 pph and beyond The Bryan tray type deaerator is unsurpassed in performance and reliability. These units are ASME Code pressurized units, and are guaranteed to deliver deaerated water at a maximum oxygen content of .005cc/l (7 PPB) and zero measurable CO2.
For efficient separation Blowdown Separator Model BDS-1630-D34-AC3 For new installations or retrofitting to existing boilers, Bryan Blowdown Separator vents off pressure from blowdown water and tempers it to an acceptable level before draining to the outside. Dry steam vents to the atmosphere. Stainless steel wear plate protects inlet connection. Large vent connection insures quiet operation. Constructed and stamped to ASME code Sect. VIII for 150 psig.
of steam and water Automatic Blowdown System All boilers require proper care and maintenance to assure optimal performance. In particular, steam boilers will operate more efficiently if serviced by a surface or bottom blowdown system. Bryan Steam can provide these systems in either manual or automatic designs. A regular blowdown procedure to remove accumulated sludge will extend the life and performance of your boiler. A Bryan system will assure that your boiler has regular blowdown on a preset schedule.
Bryan U-Tube Heat Exchangers Bryan’s U-tube heat exchangers are built to offer long life and maximum performance in all applications, including service water, space heating, radiation, swimming pool heating and various process applications. These instantaneous heaters operate with steam or water on the shellside and water on the tubeside. Bryan offers U-tube heat exchangers in sizes ranging from 4" diameter to 12" diameter and lengths up to 10', in both two and four pass designs.
