Manual

SEP/03/2008/WED 05:27
RLCS FAX No, 31 7 240 5666 P, 001/004
Installation Instructions
The M-H pre-wired Control Panel and Protectorelay,
supplied with each assembly may be mounted on
any convenient wall or structure in the boiler area.
See instruction packed with panel. Complete wiring
instructions are furnished with the control box. In
additioDj the wiring diagrams are repeated in this
instruction. Observe local codes and the National
Electric Codes for wiring external of the panel.
*
Electronic Pilot
The electronic pilot should be mounted in place of
the automatic pilot nearest the center of the boiler.
There is enough wire furnished for the largest
boiler. What wire is not used should be discarded.
Remove the automatic pilot and install the elec
tronic pilot in its place.
Electronic Control Pilot
MANUAL IGNITION
For Ndturol Gas-D4 Control Group
This Control Assembly consists of two packages:
1. Package - Electronic Control
a. M-H Control Panel including Protecto-relay.
b. Flame Rod wire (hi-temp) 10 feet.
2. Pilot Package
a. M-H Electronic Pilot
b. Wire nut
c. Ground Clamp
Proceed as follows:
1. Mount the Control Panel (see General above).
2. Remove automatic pilot. Install the electronic
pilot in its place.
3. Use the 10 foot length of high temperature flame
rod wire to make electric connection at pilot. Use
14 gauge make up wire to continue the line to the
Control Panel. Make sure a good tight connection
is made. Wire nut is provided. Tape wire to gas
manifold.
4. Ground clamp -Run ¡^14 gauge wire to the Control
Panel ground connection. Tape wire to gas manifold.
(SEE OVER)
EH 245 Kit No, 1
CANCELS; NEW
EFFECTIVE; 2/2a/64