Install Instructions

Installation and maintenance instructions Logano G215 US oil/gas-fired boilers • Issue 2012/10

We reserve the right to make any changes due to technical modifications.

Boiler block assembly7

7.1.11 Positioning the flue outlet

The flue outlet comes with sealing rope already fitted.

z Remove the washers and nuts from the threaded

studs.

z Position the flue outlet on both threaded studs on the

back section and secure with nuts.

7.1.12 Sealing boiler hubs

The reducer included with the B-Kit is required for fitting

the boiler fill and drain valve (boiler fill & drain valve).

The boiler fill & drain valve is also a component of the

B-Kit.

z Seal with teflon tape or paste the reducer into the

bottom boiler hub at the back of the boiler.

z Install the boiler fill & drain valve on the reducer.

z Close the top boiler hub on the front section with the

blank flange.

z Screw in the plug with the flat gasket into the lower

boiler hub.

Fig. 23 Fitting the flue outlet

Fig. 24 Sealing the reducer

1 Reducer

Fig. 25 Seal boiler hubs at the front section

1 Blank flange

2 Plug