Install Instructions

Boiler block assembly 7

We reserve the right to make any changes due to technical modifications.

Installation and maintenance instructions Logano G215 US oil/gas-fired boilers • Issue 2012/10

7.4.2 Insert the flue gas baffle plates

z Remove the corrugated cardboard packaging when

the block is supplied ready assembled.

z When the boiler is supplied in sections, remove the

flue gas baffle plates from the carton containing the

small iron fittings.

z Install flue gas baffle plates in accordance with the

following table into the central second flue gas pass.

The cast lugs should point towards the center of the

boiler.

z Install flue gas baffle plates in accordance with the

following table into the third flue gas pass. The cast

lugs should point outwards.

The flue gas temperature can be increased by removing

the flue gas baffle platess (Î Chapter 9.6.1, page 44).

7.4.3 Installing the burner door

The burner door can be mounted either on the r.h. side

and on the l.h. side. Installation on the r.h. side is

described below.

z Screw the two hinge pins to the front section with one

M12 × 35 hexagon bolt each.

Fig. 29 flue gas baffle plates into the second flue gas pass

(here: centrally)

Fig. 30 flue gas baffle platesinto the third flue gas pass

Boiler section 3 4 5 6 7

2. flue gas pass top – – – – –

center2–2––

bottom2–2––

3. flue gas pass 2 2 – – –

Tab. 12 Arrangement of the flue gas baffle plates

Fig. 31 Fit hinge pins (here: on the r.h. side)

1 M12 × 35 hexagon bolt