Install Instructions

Installation and maintenance instructions Logano G215 US oil/gas-fired boilers • Issue 2012/10

We reserve the right to make any changes due to technical modifications.

Boiler installation8

z Screw studs included with the B-Kit to the burner

door.

z Fit the burner to the hole circle of the burner door.

z Install burner with the correct nozzle and settings

(air, pump pressure, turbulator settings, flange

position).

z Place the seal on the studs and secure the burner

with the included nuts.

z Follow the manufacturer's direction for installation,

fine adjustment and regular maintenance

procedures.

z Wire up the burner (see Î documentation for

burner).

8.5 Providing a fuel supply

Make the fuel connection in accordance with all locally

applicable regulations. We recommend the installation

of a fuel filter.

z Visually inspect the fuel pipe and clean or replace, if

necessary.

z Install a shut-off valve into the fuel supply pipe.

z Connect the fuel pipe free of stress to the boiler.

z Check the fuel line for leaks.

8.6 Aquasmart installation

An Aquasmart controls the boiler supply temperature.

z Install Aquasmart and sensor well as specified by the

installation manual.

For operating the boiler with Aquasmart control see

instructions supplied with the controller.

Fig. 51 Burner door mounting holes

4 3/8"

5 7/8"

NOTICE

Approved burners with accessories (such

as aquastat and circulator) are also

available as a package from Buderus

Hydronic Systems.

NOTICE

For the correct burner settings see the

Î documentation for the flue system and

the Î burner.