Instruction Manual

5
MAKING CUTS
2
Caution! Wear hand and eye protection while operating the EZ Shear™
While gently pushing handle
down, pull Safety Lock pin
out, then lift handle.
Place product on table. Bring
handle down until blade
touches material.
Push the handle down
until the material is
completely cut.
Most materials listed on page (6) shear cleanly with just one cut. However, some types of laminate ooring and
ber cement siding may require cutting twice to produce a better cut.
DOUBLE CUTTING: Simply make your rst cut 1/8” to 1/4” (3mm to 6mm) longer than your mark and then
make a second cut on your mark. This is very useful to create a cleaner cut on exposed ends or when you cannot
cover the cut edge with molding or trim.
Pull Safety Lock pin
WARNING! Blade is very sharp. Keep fingers away from blade.
1
3
DO NOT USE ON HIGH PRESSURE LAMINATE OR SOLID WOOD!