Installation manual

Page 5

COFFEE BREWING

1. Insert a BUNN

ﬁ lter into the funnel.

2. Pour the fresh coffee into the ﬁ lter and level the bed of grounds by gently shaking.

3. Slide the funnel into the funnel rails.

4. Place an empty decanter beneath the funnel.

5. Pour one pitcher of tap water into the screened area on top of the brewer.

6. When brewing is completed, simply discard the grounds and ﬁ lter.

CLEANING

1. The use of a damp cloth rinsed in any mild, non-abrasive, liquid detergent is recommended for cleaning all

surfaces on Bunn-O-Matic equipment.

2. Check and clean the sprayhead. The sprayhead holes must always remain open.

3. With the sprayhead removed, insert the deliming spring (provided) all the way into the sprayhead tube.

When inserted properly, no more than two inches of spring should be visible. Push back and forth ﬁ ve or

six times.

NOTE – In hard water areas, this may need to be done daily. It will help prevent liming problems in the brewer

and takes less than a minute.

POUR IN WATER ONLY!

40305 040307