Owner's Manual

11
INITIAL BREWER SET-UP (MCP/MCPA)
1
Remove Slide Lid (A) and Water Reservoir (N)
2
Thoroughly rinse the Water Reservoir then
ll to the MAX line.
3
Reinstall the Water Reservoir.
NOTE: Filling the Water Reservoir is not
required for Automatic units with water line
installed.
4
Plug in the brewer and turn on the
Power Switch (M).
5
Press the Pod Holder Release Button
(B) and pull the Pod Holder (F) out.
Rinse thoroughly and reinstall.
NOTE: The “Rell Water Indicator” will
slowly ash until initial setup is complete.
CAUTION: Always verify the Pod Holder is
locked into place before brewing.
CAUTION: Do not attempt to remove the Pod
Holder while brewing.
6
Place a cup that will hold a minimum of
14 oz. onto the Drip Tray Grate (G).
CONTINUED