Owner's Manual

15
7) Place the empty container back onto the drip tray grate and press the COFFEE
BREW BUTTON to begin a brew cycle.
8) When the cycle has finished, empty the container. Repeat step 7 at least two
more times to remove the solution from the tank.
9) Clean the pod holder with a mild detergent and rinse thoroughly.
10) Proceed to the “Cleaning The Sprayhead/Seal” section.
CLEANING THE SPRAYHEAD/SEAL
1) Press the Power Switch into the off “O” position.
2) Unplug the brewer and allow it to cool down.
(Minimum of 1 hour.)
3) After the unit has been allowed to cool, remove the
pod holder and set aside.
4) Using your fingers, rotate the sprayhead/seal
assembly until the sprayhead and seal are removed.
NOTE: If the sprayhead and seal are separated, they must
be reassembled as they were when removed from the
brewer. Improper reassembly could result in personal
injury from scalding water.
5) Clean the sprayhead and seal with a mild detergent and rinse thoroughly.
6) Using your fingers, rotate the sprayhead/seal assembly counter-clockwise
until it is finger tight.
7) Replace the pod holder.
8) Plug in the brewer and press the Power Switch to restore power to the
brewer.
ASSEMBLING THE SPRAYHEAD/SEAL
If the sprayhead and seal are separated during removal
or cleaning, they must be reassembled properly.
1) Identify the top of the seal. The top of the seal that seats
against the roof of the sprayhead cavity has a ridge that
can be felt by running your fingers across the surface of
the seal. The bottom is smooth.
2) Identify the top of the sprayhead. The top of the
sprayhead has a star pattern and a threaded hole where
the sprayhead attaches to the brewer.
3) While carefully stretching the seal, guide the sprayhead
into the channel of the seal. Make sure it is completely
in the channel.
When properly assembled, the sprayhead will slide easily
into the channel of the seal and will not cause any buckles in
the surface of the seal. If the sprayhead seems to be difficult
to seat, and you must stretch the seal more than a slight tug,
the assembly is not together correctly.
Top
Top
P2953
P2953
P2953
P3015