Specification Sheet

BUNN
®
practices continuous product research and improvement. We reserve the right to change specifications and product design without notice. Such
revisions do not entitle the buyer to corresponding changes, improvements, additions or replacements for previously purchased equipment.
All dimensions shown in inches. 8/07 © Bunn-O-Matic Corporation
Dimensions & Specifications
Bunn-O-Matic
®
Corporation - 1400 Stevenson Drive Springfield, Illinois 62703 • 800-637-8606 • 217-529-6601 • Fax [phone] • www.bunn.com
FCT MODELS ONLY
1.
4.1
15.66
17.72
1.03
3.46
13.5
7.94 PF
PF SHOWN
8.05 SST
8.50
5.94
1.03
18.89
16.77
(1LWR/2UPR WA
RMERS)
HOT WATER
LIFT FO
R
21.40
Model Product # Volts Amps Tank Heater Total Brewing Cu. Shipping Cord
Watts Watts Capacity Ft. Weight Attached
AXIOM-15-3 38700.0000 120 15 1425 1800 4.2 gal./hr. 4.0 30 lbs. Yes
1 lower/2 upper
AXIOM-35-3 38700.0001 120/240 17.5 3500 3850 7.5 gal./hr. 4.0 30 lbs. No
1 lower/2 upper
AXIOM-15-3 38700.0002 120 15 1425 1800 4.2 gal./hr. 4.0 31 lbs. Yes
3 lower warmers
AXIOM-35-3 38700.0003 120/240 17.5 3500 3850 7.5 gal./hr. 4.0 31 lbs. No
3 lower warmers
Brewing capacity: based upon incoming water temp of 60ºF (140ºF rise) per 1/2 gallon brew time of 4 minutes.
Models listed as 120/240V must be connected to 240V electrical service. Please refer to the installation manual.
Electrical: 120 volt, 15 amp models require 2-wires plus ground service rated 120V, single phase, 60 Hz.
120/240 volt models require 3-wires plus ground service rated 120/240V, single phase, 60 Hz.
An internal terminal block is configured for connection to a 3-wire plus ground.
Plumbing: 20-90 psi (138-621 kPa). Machines supplied with
1
⁄
4
" male flare fitting.
FCT MODELS ONLY
POWER CORD
(15 AMP, 120V
MACHINE ONLY)
8.8
17.72
15.66
4.1
7.94 PF
PF SHOWN
8.05 SST
3.46
13.5
1.03
13.94
16.50
1.03
4.63
16.77
LIFT FOR
HOT WATE
R
(
3
W
A
R
M
E
R
S
R
IG
H
T
)