Installation Guide

DAILY CLEANING

CAUTION: CLEAN AND SANITIZE YOUR SERVER DAILY

NOTE: Bunn-O-Matic recommends the three step method for cleaning and sanitizing the server. The 3 step method

consists of hot soapy water using an mild, non-citrus detergent, a fresh water rinse and an aqueous sanitizing

solution using a non-chlorine sanitizer. Do not submerge the server. Failure to follow the recommended clean-

ing procedures can cause corrosion to the stainless steel surface and damage the vacuum seal. USE OF ANY

CHLORINATED PRODUCT VOIDS THE FACTORY WARRANTY.

1. Empty server completely by opening faucet. Remove lid, ﬁll server with approved multi-purpose cleaning

solution and thoroughly clean inside of server. Drain cleaning solution.

2. Rinse server thoroughly using fresh water rinse.

3. Remove faucet handle/stem assembly by unscrewing the faucet bonnet just beneath the faucet handle.

4. For Models with Mechanical Sight Gauge: Lift sight gauge slide and pull sight gauge tube from shroud.

NOTE: Be sure to not lose washer.

5. Using approved multi-purpose cleaning solution, wash and rinse faucet spout & faucet tube, using clean

and sanitized cleaning brush supplied by manufacturer.

6. Using approved multi-purpose cleaning solution, wash. rinse, sanitize and air dry ﬁll tube in lid assembly

using cleaning brush supplied by manufacturer.

7. For Models with Mechanical Sight Gauge: Use cleaning brush supplied by manufacturer to thoroughly

clean sight gauge tube.

NOTE: Never submerge the Digital ThermoFresh

Server Display or sensor assembly in water.

8. Disassemble the faucet/stem assembly. Thoroughly wash all faucet parts and lid in a mild detergent and

water solution. Rinse the parts in hot water. Allow the parts to soak in sanitizer solution for ﬁve (5)

minutes, then air dry completely.

9. Remove drip tray and drip tray cover. Thoroughly wash in approved multi-purpose cleaning solution.

Rinse parts in hot water.

10. Reassemble faucet handle/stem and attach faucet handle/stem and lid to dispenser. For Models with

Mechanical Sight Gauge, assemble the sight gauge tube and washer. When reassembling -

CAUTION: DO NOT over-tighten faucet bonnet - HAND TIGHTEN ONLY.

11. Clean the entire outside surface of the server using a clean SOFT, Non-abrasive cloth dampened with any

mild, non-citrus, non-abrasive, liquid detergent.

12. Fully ﬁll server with non-chlorine cleaning solution and allow to sit for no more than ﬁve (5) minutes, then

drain through fully open faucet. Allow to air dry.

PERIODIC CLEANING - Models with Digital Sight Gauge only

1. Remove the lid assembly from the server.

2. Wipe the surface of the display unit, and area under the lid assembly with a clean damp cloth.

3. Wash the entire outside surface of the lid assembly with a mild detergent and water solution and rinse

with hot water. DO NOT SUBMERSE.

NOTE: Thoroughly cleaning the lid assembly will prevent inaccurate level readings.

4. Replace the display unit and lid assembly.