Troubleshooting guide

Bunn-O-Matic Corporation
13
Accessing the Inside of the Machine
The majority of service work done to a JDF-S will require the service technician to access the inside of the unit. The
unit has four removable panels to facilitate access- the top panel, the two side panels, and front splash panel. De-
pending on the repair the technician may have to remove one or all of these panels.
In order to work safely the power should be disconnect-
ed prior to removal of any body panel. Once the panels
are removed the power can be reconnected in order to
troubleshoot the machine.
Top Panel
Thetoppanelissecuredwith4smallatheadscrews.
To the remove the panel, remove the four screws, lift
the panel up and away from the dispenser’s body.
Side Panels
Eachsidepanelissecuredwith4smallathead
screws. Once the screws have been removed pull the
side panel away from the dispenser.
Front Splash Panel
Thispanelcanberemovedbyrstremovingthedrip
tray to gain access to the two screws securing the
splashpanelinplace.Removethe2atheadscrews
then slide the splash panel down the pull away from the
dispenser.
Removing the Door Cover
The door cover may be removed if you need to gain access to the lighting
circuit, switches, switch board or membrane switches.
Step 1: Disconnect unit from power source.
Step 2: Remove the 5 screws securing the door cover to the door assembly.
Step 3: If unit uses a membrane switch disconnect the 6 pin connectors from
auxiliary switch board. If the unit uses mechanical switches disconnect at the
harness molex pin connector.
Step 4: Set door cover aside.
Machine Function and Operations
Electronic Group
Step Down Transformers (A and B)
The top step down transformer connects to J-12 connector, marked
“Right Power” on control board. The transformer is responsible for
operating dispense stations 3 and 4 known as right middle and
right dispense stations.
The bottom step down transformer connects to the J-6 connector,
marked “Power” on the control board. The transformer is responsi-
ble for the main power for the control board, machine and dispense
stations 1 and 2 known as left and left middle.
A
B
C
D
E
F
H
G
I
Top Lid
Rear Panel
Ambient
Product Line
Entry
Air Filter
Right Panel
Lower
Splash Panel
Left Panel
Drip Tray & Grate
Refrigeration
Charge Decal
Serial Number &
Data Plate
BezelRetainer
Door Cover
Flavor Label
Holder
Bezel
Portion Control
Switch Membrane