Troubleshooting guide

JDF Silver Series Training Manual
4
Installation
Site Requirements
Space
• Counter able to support 150 lbs. (68 kg)
• Minimal clearance is required between the machines side and the wall or another appliance
• Minimum clearance of 4” behind machine
• Minimum clearance of 8” above machine
• JDF-2S approx. dimensions (H 33 x W 10 x D 25.5)
• JDF-4S approx. dimensions (H 33 x W 16 x D 25.5)
Plumbing
• 3/8”arewaterconnection
• Watersupplymustbecapableofproducing3uidoz.asec
• A shut-off valve should be installed in the line before the machine
• Connected to cold water
• Water pressure 20-100psi, set to 50psi if regulator is needed
Electrical
• 115VAC/208VAC
• Dedicated 20AMP Circuit with proper breaker and receptacle
• Receptacle within 5 feet of machine
Prepping Machine for Install
Step 1: Verify that all of the site requirements have been met.
Step 2: Unbox the machine and all the parts.
Step 3: Place the machine in the desired location on the counter.
Step 4: Document the complete serial number of the machine.
Install Outer Door Cover
Step 1: Connect the ribbon cables from the door cover to the control board. When connecting the ribbon cables
ensure that the number on the cable is at the top of the ribbon. For models without the portion control option
you will only need to connect the door and the door cover with a molex connector.
Step 2: Place door cover over the door.
Step 3:Securethedoorcovertothedoorusingthevescrewsprovided.
Water Supply Install
Step 1: Flush water lines.
Step 2:Attachtothettingattherearofthemachine.
Step 3: Turn on water and check for any kinks or leaks in the line.
Install the Air Filter
Step 1:LocatethelterandtheVelcrostripssupplied.
Step 2:PlaceVelcrostripsonthelterandonthecoilsattherearofthemachine.
Step 3:SecuretheltertothemachineusingtheVelcro.
Afteryouhaveinstalltheairlterverifythattherefrigerationswitchisintheoffposition.