Troubleshooting guide

Bunn-O-Matic Corporation
5
Initial Fill
CAUTION:Thedispensermustbedisconnectedfromthepowersourcethroughouttheinitialll,exceptwhen
speciedintheinstruction.
Step 1. Remove drip tray assembly and splash panel from the dispenser. Replace the drip tray.
Step 2. Connect the water source to the back of the dispenser.
Step3.Pullthelltubefromthedispenser,removetheplugandconnectittothedispensenozzle.
Step 4. Set the Program Switch (near main control board) to the ON position. (On older models without program
switch, set the Dispense Lockout Switch to the OFF position)
Step 5. Connect dispenser to the power source. Press and hold the dispense button for the dispense station that the
tube is connected to for 10 seconds, until you hear the water valve turn on. (For Portion Control machines,
press and hold the PLUS/STOP switch)
Step6.Monitorthewaterbathllleveluntilwaterstartstotricklefromtheoverowtube.Thenpressthe 
 dispensebuttonagaintostopthellprocess.
NOTE:Thelltimermaytimeoutbeforellingiscomplete.Pressandholdthedispensebuttonfor10
seconds to start again if needed.
Step 7. Turn ON the refrigeration switch near the main control board. This will start the water bath pump circulation.
Step8.Checkwaterlevelintheoverowtubeandtopoffthetankifnecessary(Step5).
Step9.Disconnectthelltubeandallowexcesswatertodrainintothedriptray.Replacetheplugintheendofthe
 lltubeandstorebackintothedispenser.
Step 10. Set the Program Switch (near main control board) to the OFF position. (On older models without program
switch, set the Dispense Lockout Switch to the ON position)
Step 11. Replace the splash panel and drip tray.
Step 12. It will take several hours to create the ice bank required for full dispenser performance. During this time,
some further trickling from the water bath is expected due to expansion caused by ice bank formation. While
the refrigeration system is creating the ice bank, the dispenser may be readied for use as described in
Loading,